Advertisement
Quick Links
Congratulations on your purchase! To get optimum performance from your Pearl drum set,
Crash Cymbal
Cymbal Boom Stand
Hi-Hat Cymbal
Hi-Hat Stand
Snare Stand
Drum Throne
*Illustrations shown in this manual are Decade Maple drums and 930 series hardware.
PEARL DRUMS
E X L・E X X
Instruction Manual
please read this Instruction Manual first before playing.
Tom Tom
Snare Drum
* Cymbals are not included in the set.
Tom Holder
Tom Tom
Bass Drum
Floor Tom
Set-Up Example
Drum Pedal
Ride Cymbal
Cymbal Stand
Advertisement
Summary of Contents for Pearl Drums Decade Maple Export EXL
- Page 1 PEARL DRUMS E X L・E X X Instruction Manual Congratulations on your purchase! To get optimum performance from your Pearl drum set, please read this Instruction Manual first before playing. Crash Cymbal Tom Holder Cymbal Boom Stand Ride Cymbal Hi-Hat Cymbal...
- Page 2 Bass Drum Assembly 3. Turn the Shell over to the batter side and place the other Head and Bass Drum Hoop on the Shell. The The Bass Drum is packed with the Shell, Bass Drum batter side Bass Drum Hoop has a Hoop Protector Hoops, Heads and Parts unassembled.
- Page 3 Floor Tom Assembly Tom Tom Setting The Floor Tom is packed with the Shell, Steel Hoops, Insert the long ends of the Tom Holders into the Tom Heads and Floor Tom Legs unassembled. Please follow Holder Bracket on the Bass Drum as shown (Fig.8) and the assembly instructions below to assemble the Floor tighten the Wing Nuts on the Tom Holder Bracket.
- Page 4 Setting the Cymbal / Boom Stand Reversible Cymbal / Boom Stand Assembly Nut Assembly Open the legs of the Stand Base to form a stable tripod and tighten the Wing Bolt. Insert the Center Tube Assem- Unscrew the Reversible Nut from the Cymbal Post and bly into the Die-Cast Joint of the Stand Base and tighten remove it along with the Upper Felt Washer.
-
Page 5: Basic Tuning
Setting the Snare Drum Basic Tuning Open the legs of the Stand Base to form a stable tripod Gradually tighten the Tension Bolts using a crisscross and tighten the Wing Bolt. Loosen the Wing Nut on the pattern as shown. Tap the Head at each Tension Rod in a Tilter of the Basket Assembly and adjust the angle of the zone between 20mm and 30mm from the rim as shown Basket as shown (Fig.13).