Olympia RS 50 Assembly Manual

Assembly Manual
Additional Door Lock RS 50 / Additional Door Lock RS 50R
C1
2
C2
4
7
1
5
6
8
14
15
Lock Unit
3
1
2
3
4
Door Lock RS 50R
13
14
15
16
9
10
Intended Use
12
The additional door lock increases property security when residents are inside the respective building
or room. Option: The installation of an outer cylinder enables the additional lock to be used on the door
even when the user is absent.
The additional door lock is intended for apartment and house entrance doors made of wood, steel, alu-
11
minium and composite materials. In the case of plastic and compound materials, a metallic profile must
be available at the assembly positions or a metallic plate underlaid on the other side.
Any other use is considered unintended use. Unauthorised modifications or reconstructions not de-
scribed in the manual are not permitted and could cause the product to be damaged.
Safety Instructions
16
I
MPORTANT
additional door lock as described in this assembly manual. Only use the
assembly material supplied.
I
MPORTANT
casionally with a dry cloth. The mechanism inside is already greased at the
factory. During assembly, pay attention that no wood chippings or similar
bits get into the lock cases when open.
13
Door Lock RS 50
Lock case 5 Spacer base plate
Base plate 6 Screw 5x35
Screw M5x10 7 Frame dowel
Screw 5x25 8 Additional spacer plate
9 Strike plate
10 Screw M5x15
Door guard
11 Lock case
Retaining bolt
12 Screw M5x15
Retaining bolt spring
Safety cotter pin
Read the assembly manual thoroughly and observe the information contained during installation.
Keep the assembly manual in a safe place for future reference.
W
! Risk of suffocation! Children can swallow small parts,
ARNING
packaging and protective foils. Keep the product and packaging
out of reach of children!
! Improper assembly can lead to property damage. Install the
! DO NOT use spray oils or anything similar. Clean the catch oc-
Tools Required
■ Cross-tip screwdriver
■ 3 mm wood drill
■ 10 mm masonry drill
■ Marker, scriber
■ Possibly a tape measure and
spirit level
Option (when using an
outer cylinder)
■ 32 - 35 mm hole cutter
■ Pliers to shorten the catch