Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for APG FT-100 Series
Summary of Contents for APG FT-100 Series
- Page 1 P R O D U C T S G R O U P, I N C. Operator’s Manual FT-100 Series Mechanically Activated, Narrow Angle Float Switch Rev. A3, 6/09 Automation Products Group, Inc. APG...Providing tailored solutions for measurement applications 1.800.561.8187 information@itm.com www. .com...
-
Page 2: Table Of Contents
Rev. A3, 6/09 Table of Contents Warranty ..................3 Introduction ..................4 Specifications .................. 4 Installation ..................5 Wiring Diagrams ................6 Cable Weight ................... 7 Automation Products Group, Inc. APG...Providing tailored solutions for measurement applications 1.800.561.8187 information@itm.com www. .com... -
Page 3: Warranty
No representation or warranty, express or implied, made by any sales representative, distributor, or other agent or representative of APG which is not specifically set forth herein shall be binding upon APG. APG shall not be liable for any incidental or consequential damages, losses or expenses directly or indirectly arising from the sale, handling, improper application or use of the goods or from any other cause relating thereto and APG’s liability hereunder, in... -
Page 4: Introduction
CPE jacket Note: This switch is not recommended for controlling 1.) electrical loads less than 100 mA, 12 VAC, or 2.) non-arcing electrical loads. Automation Products Group, Inc. APG...Providing tailored solutions for measurement applications 1.800.561.8187 information@itm.com www. .com... -
Page 5: Installation
Figures B or C. Check installation. Allow system to cycle to ensure proper operation. Note: All hose clamp components are made of 18-8 stainless steel material. Automation Products Group, Inc. APG...Providing tailored solutions for measurement applications 1.800.561.8187 information@itm.com www. .com... -
Page 6: Wiring Diagrams
For the FT-100A or FT-100B connect cable leads directly into control device as shown in Figure B. Figure B For the FT-100C connect cable leads directly into control device as shown in Figure C. Figure C Automation Products Group, Inc. APG...Providing tailored solutions for measurement applications 1.800.561.8187 information@itm.com www. .com... -
Page 7: Cable Weight
Align clip with weight channel and slide towards switch cable as shown in Figure D. Snap clip snugly up to cable, moving clip to tightest possible position. Figure D Automation Products Group, Inc. APG...Providing tailored solutions for measurement applications 1.800.561.8187 information@itm.com www. .com...
Need help?
Do you have a question about the FT-100 Series and is the answer not in the manual?
Questions and answers