Summary of Contents for Banjo Dry-Mate DM150SS Series
Page 1
D ry- D i sc onnect s D M100SS, D M150SS & D M2 00 S S SE R I E S 1 " FU LL PORT, 1 ½ " FUL L P ORT & 2 " STAN DAR D PORT S TA I N LE S S S TE EL ®...
® The cam arm style of connection is one of the most recognized type of fluid connector in use. The Banjo Dry-Mate uses this style of connection for easy, quick, and positive engagement of the Dry-Mate components. The cam arms and mating profiles are 316SS for corrosion resistance.
Seals 2" 1½" ® WARNING! The Banjo DM100SS, DM150SS & DM200SS Series should not be used at pressures above the Maxi- mum Pressure or at temperatures above the Maximum Temperature or below the Minimum Tempera- ture indicated. Use outside of these parameters could cause failure of the fittings, which may result in significant injury or death. Although sold separately, the Male should only be used with the Female, and the Female should only be used with the Male.
OPERATION Step 1 To attach the two fittings together, make sure the faces of the two fittings are free from dirt or other foreign material. Make sure the seal is properly installed and without damage. Align the two fittings together as shown in Figure 1. Cam Arm Cam Arm Male...
Page 5
Step 3 In this position, the handle of the Female must be rotated before the handle of the Male can rotate. Rotate the handle of the Female to the fully open position. When the female handle is fully opened, the locking yoke will engage the clamp arms and prevent the clamp arms from being opened while the handle is in the fully open position.