QUICK START
Simple Operation Guide for:
MONTBLANC & MONTBLANC PLUS
Listed below are a few quick steps to ensure you able to use the installed
radiator. All of the information used below can be found in the instruction manual
every radiator.
Listed below are a few quick steps to ensure you able to use the
installed Calthermic Montblanc radiator. All of the information
used below can be found in the instruction manual supplied
First Switch on
with every radiator.
Once the radiator has been fitted to the wall and either plugged into a domestic three
hard wired into a spur/flex outlet, by an adequately qualified contractor, simply turn o
FIRST START
FIG 1
adjust the "call" temperature to your desired level. You can now operate the radiator
Fig 1
manually, using the ON button to bring the radiator in and out of standby mode. The
radiator will remember the temperature you set prior to being put in stand-by mode.
Operation Guide – MONTBLANC Radiat
Once switched on the main screen will flash, pressing
will stop the screen flashing.
Once the radiator has been fitted to the wall and
either plugged into a domestic three pin socket or
This will now be the display, although newly out o
hard wired into a spur/flex outlet, by an adequately
radiator will be set at a temperature of 35 degree
qualified contractor, simply turn on the radiator.
either the + or – buttons will adjust the "call" te
Once switched on the main screen will flash, pressing
any button will stop the screen flashing.
your desired level. You can now operate the radia
This will now be the display, although newly out of
using the ON button to bring the radiator in and o
the box the radiator will be set at a temperature of
mode. The radiator will remember the temperature
35 degrees. By pressing either the + or - buttons will
to being put in stand‐by mode.
Calthermic
M
su