Canarm 3580LED-PL3WHT-C Quick Start Manual

1-800-265-1833 (English) / 1-800-567-2513 (French) Monday through Friday 8:00 AM to 5:00 PM E.S.T.
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
!
SAVE THESE INSTRUCTIONS
SAFETY PRECAUTIONS:
This fixture is equipped with a polarized plug (a plug having one blade wider than the other). This
plug will fit in a polarized outlet only one way. This is a safety feature. If you are unable to insert the
plug fully into the outlet, reverse the plug. If it still will not fit, contact a qualified electrician. Never
use with an extension cord unless the plug can be fully inserted.
PACKAGE CONTENTS
DESCRIPTION
PART
A
B
C on/off switch
D
E 6' extension cord
F
G
INSTALLATION:
OPTION #1 - SURFACE MOUNT
Surface
Can
Housing
Lens Cover
Mounting
Screws
Lens cover
puck light
10"
link
power cord
5'
1'
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: (613) 342-5424, Fax: (800)263-4598
LED UNDERCABINET
QUESTIONS OR CONCERNS CONTACT CANARM AT:
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
LED pcuk light
Plug
6' cord
Wire clips
Screw
1.
Remove lens cover by
twisting counter-clockwise.
2.
Attached puck to mounting
surface with 3 mounting
screws (included).
Replace lens cover.
3.
Link puck with power cord
Secure cord to mounting
surface using wire clips
included.
Plug cord into power outlet.
PUCK
QTY
3
1
1
1
1
6
9
OPTION #2 - RECESSED
2 1/8"
Lens Cover
Notch
Reflector
Optional hardwire kit (sold separately).
3580LED-PL3WHT-C
3580LED-PL3NKL-C
TOOLS AND MATERIALS REQUIRED:
Phillips Wire Cutters
Screwdriver
Wrench
Pliers
1.
Drill a 2 1/8" hole in the
underside of the cabinet
Surface
2.
Remove lens cover by
Can
Housing
twisting counter-clockwise.
3.
To remove the housing cover
lift cord up from notch
Surface
and twist the reflector
Can
Housing counter-clockwise.
Discard housing.
4.
Feed cord through drilled
hole and push puck snugly
into place. Secure with
3 mounting screws
Reflector
(included).
Replace lens cover.
Mounting
5.
Screws
Link puck with power cord.
Plug cord into power outlet.
(see step 3 in surface
Lens Cover
mount instruction)
1/14
Wiring supplies
as required by
electrical code