Installation and Maintenance
SERIES TTF THERMOSTATIC STEAM TRAP AND AIR VENT
This bulletin should be used by experienced personnel as a guide
to the installation of TTF thermostatic steam traps and air
Selection or installation of equipment should always be
vents.
accompanied by competent technical assistance.
to contact Armstrong or its local representative if further
information is required.
Armstrong Series TTF Stainless Steel Thermostatic Steam Traps are
of the balanced pressure type and provide positive intermittent
Operating pressure ranges from 0 to 300 psig.
discharge.
Table for orifice size and pipe connections.
Model
TTF-1
Straight-Thru
Right Angle
I
When installing Series TTF traps, observe good piping practices
and local codes.
Figure 1 shows a typical Series TTF
steam trap installation.
pocket and strainer prolong the
trap's service life by protecting the
internal mechanism from scale and
dirt.
Valves in the inlet and
discharge lines allow the trap to be
isolated for maintenance.
Series TTF traps may be piped in
either a vertical or horizontal
position.
When installing a TTF series trap,
observe the following rules:
Orifice
Connections
Size
The dirt
We encourage you
Pipe
or
I
Equipment
Drip
Pocket
Return Header !I
Figure 1.
IB-33
See
Series TT