Page 1
™ InvisiPac Transformer 333349E Upgrade Kit To operate 240V InvisiPac units with a three-phase 400V or 480V electrical supply. For professional use only. Not approved in explosive atmospheres or hazardous locations. 127567 400V Transformer Upgrade Kit 127568 480V Transformer Upgrade Kit...
Page 2
This transformer must be installed by a qualified electri cian to operate 240V InvisiPac units with a three-phase 480V electrical supply. NOTE: Installing the transformer kit changes the model of the InvisiPac system. Refer to the InvisiPac system manual 333347 for model information.
Page 3
Parts Parts 9. Run wires/cabling from transformer enclosure (4) through plastic cable bushing (3) into main electrical enclosure. 400V Transformer Upgrade, 127567 10. Connect fan connector from transformer enclosure 480V Transformer Upgrade, 127568 into J7 on AWB. 11. Connect black wires from transformer enclosure (4) to J2 on AWB board according to the table below: Terminal Wire Label...
Page 4
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of eighteen months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.