Penguin Engineering Systems PESIplex PTX2 User Manual

Multi-Button Key Tag Transmitter PTX2/PTX4 User Manual
PESIplex Multi-Button Key tag Transmitter (PTX2/PTX4) User Manual
The PTX2 & PTX4 series of transmitters are designed to work with the PESIplex PTX-433 Receiver module. These
are battery operated low powered hand held transmitters. The PTX2 & PTX4 transmissions are encrypted to
ensure the highest level of security. Each transmission will emit a unique code to prevent code grabber devices
from operating. These technologies will prevent an unauthorized person to gain access to restricted areas. All
codes are electronically programmed by the factory and ensured to be unique.

Operating Instructions:

1. Press the desired button for at least one second to activate the transmitter. A red LED indicator will flash
as the codes are getting transmitted. Press and holding the button for more than 3 seconds will stop the
transmission; this reduces the unintentional transmissions and preserves the battery life.
2. If the red LED indicator does not light up when you press any one of the button, replace the battery (3V
Lithium Ion battery – CR2032).
Note: Radio frequency controls provide reliable and convenient means to remotely control devices.
However, there are some limitations. A receiver can only respond to one transmission signal at a time and
may be blocked by radio signals operating on the same center frequency.
Rev: FCC- 012-B Date: January 20, 2010
Penguin Engineering Systems Inc.
Page 1