Page 1
Ceramic Working Pressure Range (kPa) Working Temperature Range (°C) Nominal Flow Rate (LPM) Finish Chrome NOTE: Galvin Specialised continually strive to improve their products. Specifications may change without notice. TOOLS REQUIRED Power drill Spanner and hex key ...
Page 2
Ezy-Grip INSTALLATION INSTALLATION COMPLIANCE: Galvin Specialised products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.
Page 3
Version 2, 13 June 2017, Page 3 of 4 1. Disassembly 2. Fit basin body Disassemble components, leaving bottom Insert the basin body assembly up through the pre- nut on the body. cut hole. Do not remove the ceramic cartridge 3.
Page 4
Turn on water WARRANTY The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.