Page 1
T13C/R1201 Table Updater for Seating Management U S E R M A N U A L Usage, Installation, Warranty and Service Information Long Range Systems, LLC 4550 Excel Parkway, Suite 200 ddison, TX 75001 800.437.4996 www.pager.net •...
· The current status of each table is always available to the hostess station. · Status can be changed from the floor or the hostess station. · The R1201F receiver is updated directly through a radio transmitter located in the T13C hand held keypad.
NOTE: The T13C transmitter should be charging whenever not in use. 1. Unwrap all T13C transmitter and R1201F receiver components. 2. The T13C transmitter is portable and battery powered. It is charged in the same power charger used for LRS paddle and star pagers.
Press the TEST key to check the battery. The display shows a number to indicate the battery charge (5 is fully charged and 1 is very weak). Reset If the battery has been allowed to totally discharge, it may be necessary to reset the T13C for it to function properly. To reset the T13C: 1. Put the T13C on charge.
T13C SPECIFICATIONS Required voltage: One 110/220V outlet for the R120F Receiver and Charger for T13C Transmitter . Operating Frequency: 448.000MHz Transmit Power: 10 mW Operating Range: pproximately 1/4 mile (unobstructed) SERVICE QUESTIONS AND ANSWERS My system is malfunctioning - What do I do?
- Connect the equipment into an outlet on a circuit Long Range Systems, LLC reserves the right to make changes without different from that to which the receiver is connected. further notice to any products herein. LRS, LLC makes no warranty, rep-...