7230 INSTALLATION OPERATING AND MAINTENANCE INSTRUCTIONS SAFETY WARNINGS SIDE OF THE CABLE. cable ferrule flush, only on the free end of the cable. THIS IS A SAFETY Installation, service and maintenance Do not exceed the capacity or reduce REQUIREMENT. (Figure 1) repairs must be carried out by quali- tension below the minimum rating of fied personnel. They should be alert- the spring as damage will occur and ed to the dangers associated with...
Page 4
ment to pass completely through the THAN THE SPRING CAPACITY OF Remove the housing cover and drum spring. BALANCER. IMMEDIATELY lid. Install the spring removal tool into LOCK THE DRUM AND MOVE THEM the slot on the safety detent pin and QUICK CHANGE CABLE UP TO THE NOZZLE AND TIGHTEN pull the pin out towards the housing...
Page 5
is functional. The inner lip should fit rubber ball onto the free end and then slide down onto the shaft. Insure the snugly into the inner lip of the shaft attach the cable clamp 6.5 feet from woodruff key is positioned correctly and should not be more than 1/8 inch the ferrule end. Secure a new cable so the snap ring groove clears the larger than the shaft. Discard a dam- ferrule without crimping the cable di- top of the worm gear. Install the snap...
This manual is also suitable for:
7230-17230-27231 series7230-37230-57230-4...
Show all