Wave-Led Deck 35 User Manual

Deck 35
1165, 1166, 1167
PLEASE READ INSTRUCTIONS CAREFULLY BEFORE COMMENCING ANY WORK
Do not look directly into the light source.
For use with supplied UL approved electronic plug in driver only.
Do not attempt to disassemble any parts; all are sealed units.
When outdoors, only plug the power supply into a GFCI socket that is marked "wet location".
Do not attempt to connect further light sources unless otherwise stated.
This deck must be installed in accordance with all local codes and ordinances.
This brochure is for illustration purposes only and is not meant to wholly replace a licensed professional.
Any use of this product must be in accordance with all local zoning and building codes.
The consumer assumes all risks and liability associated with the use of this product.
The consumer or contractor must take all necessary steps to ensure the safety of everyone involved in the installation, including, but
not limited to, wearing the appropriate safety equipment.
This product comes with a limited 2 year manufacturers warranty as standard, but can be extended to 5 years if registered by the
purchaser via the Wave-LED website within 28 days of purchase. The seller expressly disclaims any and all liability arising out of the
use or ownership of the product, including disclaiming incidental and consequential damages, unless otherwise required by state
law. For full terms and conditions please refer to our website www.Wave-LED.com.
Wave-LED Inc. +1 213 3256464 1240 Rosecrans Ave Ste 120 Manhattan Beach California 90266
• Main low voltage cable is intended for shallow burial - less than 6" (152mm)
• Power supply unit can support a maximum of up to 10 individual lights.
• Power supply unit must be mounted at least 1' (0.3m) above ground level.
• Power supply unit is not suitable for use with dimmers.
• Please contact us if you require additional lengths of main voltage cable.
• Cannot be used with an extension cord.
• CAUTION: FOR USE ONLY ON A BRANCH CIRCUIT PROTECTED BY A CLASS A TYPE GROUND FAULT CIRCUIT INTERRUPTER.
• FOR USE WITH LANDSCAPE LIGHTING SYSTEMS ONLY
• THIS DEVICE IS ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE SUITABILITY OF THE COMBINATION
SHALL BE DETERMINED BY CSA OR LOCAL INSPECTION AUTHORITIES HAVING JURISDICTION
• DO NOT CONNECT TWO OR MORE POWER SUPPLIES IN PARALLEL.
• LANDSCAPE LIGHTING SYSTEMS ARE FOR OUTDOOR USE ONLY.
• NOT FOR USE IN DWELLING UNITS.
• POWER SUPPLIES ARE FOR OUTDOOR USE ONLY.
• DO NOT MOUNT POWER SUPPLY OR LUMINAIRES WITHIN 3m OF A SWIMMING POOL OR SPA.
INSTALLATION
The Deck 35 kit has been designed for use in decking and combines some innovative features to make installation
easier. 2 x pre-wired looms each with 5 LED heads plus a 16' (5m) extension cable allow longer runs to be achieved.
Wiring loom can be into the deck during construction.
Heads are interchangeable allowing di erent sizes and colours to be operated from one power source (excluding RGB option).
Minimum board thickness 1/2" (12mm).
Minimum cavity depth 3 5/32" (80mm).
Step 1
Choose the most suitable location for plugging in the UL approved plug.
Do not plug in at this stage.
Step 2
Choose the location for each of the 10 heads.
Ensure cables are long enough to connect to the desired positions.
before drilling any holes.
ISSUE 1 01/09/2017 www.wave-led.com technical@wave-led.com P1/3