EX (ELA CSUS12) or LQM (ELA LQMUS12)
CAUTION: For safety and proper operation, read and follow instructions carefully before installation.
1.READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
2. Before wiring to power supply, turn off electricity at fuse or
circuit breaker.
3. Disconnect AC power before servicing.
4. All servicing should be performed by qualified personnel.
5. Consult your local building code for approved wiring and
installation.
IMPORTANT NOTE:
1. Require the use of a 4" octagon junction box (not supplied) for mounting.
2. All exit sign electronics must be in the exit sign housing.
3. Note: Installation process is the same for both the EX and LQM exit signs, but the correct kit needs to be used
due to differences in the housing mounting brackets.
Refer to product instruction sheet for wiring diagrams, maintenance instructions and warranty information.
INSTALLATION INSTRUCTIONS
EXIT SIGN STEM KIT
IMPORTANT SAFEGUARDS
(qty. 2)
(qty. 2)
Fig. A
6. Do not use outdoors.
7. Do not mount near gas or electric heater.
8. Fixture must be grounded to avoid potential electric shock.
9. Equipment should be mounted in location and at heights where it will
not readily be subjected to tampering by unauthorized personnel.
10. The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
11. Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS
(qty. 2)
(qty. 2)
Parts Description
page 1
Pendant
Mounting Canopy
Universal Mounting Bracket
Screw, 8-32 X 1 1/4"
Retaining Washer
Palnut
Upper housing Bracket
Lower housing Bracket
Screw, 8-18 x 1" PH type 25
Fig. B