Attention! Please read this manual carefully before you start! SAFETY PRECAUTIONS Please protect this equipment from falling, impacts and excess humidity. BEFORE YOU START 1 . S C S ( S e c r e t C o n n e c t i n g S y s t e m ) pedalboard is designed to use with SCS series pedals.
Page 3
4. Pedal Board is now open. 5. Place the pedals on the Pedal Board. The pedals' sequence is no important, except of FS-12 (refer to p.8). 6. Attach the SCS pedals to the Pedal Board with the captive screws.
Page 4
7. Connect the pedals to the Pedal Board with the dedicated cables, which are supplied accessories (spare cables included as well). 8. The SCS series has the FS-12 pedal, which can be used either as a stand-alone device or as a common bypass device for the whole Pedal Board.
Page 5
10. This is how an assembled, ready-to-use Pedal Board looks from inside. 11. Putting back the bottom cover, assemble the Pedal Board. 12. Tighten the cover's side-knurled screws.
13. The Pedal Board is now ready to use. Guitar is connected to the rightmost pedal's input, while leftmost pedal's output is connected to the amplifier. Power supply for all the SCS pedals attached is cross-connected from inside of the Pedal Board. One external power supply unit connected to any pedal is enough to use.