Page 2
THESE ASSEMBLY FITTINGS FOR THE KYOTO COLLECTION INSTRUCTIONS APPLY TO (only additional tool required is a Philips head screwdriver): THE FOLLOWING MODELS: • Kyoto Bed, Kyoto Bed with Place the rails on the legs as Headboard • Kumo Bed, Kumo Bed with shown, then screw in the flat head Headboard bolts with the allen key.
Page 3
Using the dome headed bolts connect the headboard panel to the side/centre rails - secure with the half moon washers and nuts. Tighten with the spanner. Position the head end panel and foot end panel - secure using the small * If you have ordered a bed without a headboard please washers and screws provided.
Page 4
Place the end caps on the sprung slats and attach (centre of the gently curved slats should be upwards) * Please note - if you have ordered a standard single (90cm) or super-king (180cm) bed base you will also receive a set of double slats with sliders. These slats are for holes 4-9 from the head of the bed base.
Page 5
THANK YOU FOR BUYING A BED FROM DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP T: 0114 272 1984 E: SALES@NATURALBEDCOMPANY.CO.UK W: WWW.NATURALBEDCOMPANY.CO.UK...
This manual is also suitable for:
Kumo bed with headboardKobe bedKumo bedKyoto bedKobe bed with headboard