Advertisement
Quick Links
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1)This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
OFF
WIRELESS MICROPHONE
CH4
RF
CH3
CH2
AF
CH1
OFF
OFF
WIRELESS MICROPHONE SYSTEM
VOL
CHA
CHB
CH4
CH8
RF
RF
CH3
CH7
POWER
CH2
CH6
AF
AF
CH1
CH5
VOL
VOL
USER GUIDE
Advertisement
Summary of Contents for ProAudio UHF-11E
- Page 1 FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
- Page 2 REAR (FIGURE 2) Antennas-to receive signals from the transmitter Balance-Output Frequency Channel Selecting Switch Unbalanced Audio and Mixed Output Power-DC Input DC IN DC IN 12VDC 12VDC ANT.B ANT.B ANT.A CHANNEL CHANNEL CHANNEL Thank you for purchasing the Wireless Microphone System and congratulations on your choice. 4 3 2 1 MIXED OUTPUT 4 3 2 1...
- Page 3 3. Insert two 1.5VAA alkaline batteries into the battery compartment. Two fresh 1.5V alkaline batteries should typically provide 8 hours of performance time. Two fully charged 1.2V Nicad batteries (1800 mA) should provide 12 hours of performance time. (FIGURE 5) When the LOW BATTERY light on the transmitter turns on, you have 20 minutes of less of useful battery life remaining.
- Page 4 902.6 to 925.3 MHz 100 dB <-105 Phase Lock Loop Dual Channel receiving > 102dB 213x115x42mm Transmitter <10mW PAGE 5 PAGE 6...