Gauge For Atmospheric For Low NOx Models C-R206AE-406AE Models C-R207AE-407AE FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids or other combustible materials in the vicinity of this or any other appliance. To do so may result in an explosion or fire.
Page 2
Before Starting NOTE: These instructions are intended primarily for use by qualified personnel specifically trained and experienced in the installation of this type of heating 1) Turn off power to the heater at the circuit breaker. equipment and related system components. Installation and service personnel must be licensed 2) Turn off gas supply.
Page 3
7. Locate and install the 2” CPVC manifold adapter 12. Locate and install the flow switch cover, if not onto the Outlet side (see Fig.1). Careful not to strip already installed. the threads on the manifold adapter. 13. Locate and install the T&P gauge on the side of 8.
Page 4
26. Cycle the heater a few times to verify flow switch operation. FLOW SWITCH WIRES Fig 5: Completed Assembly CONNECTED TO “SPARE” JUMPER Fig 4: “Spare” Jumper Connections www.raypak.com Raypak, Inc., 2151 Eastman Avenue, Oxnard, CA 93030 (805) 278-5300 Fax (805) 278-5468 Litho in U.S.A.