3B SCIENTIFIC 1000539 Instruction Manual

3B SCIENTIFIC
1000539 (115 V, 50/60 Hz)
1000540 (230 V, 50/60 Hz)
Instruction manual
06/14 MEC
1. Safety instructions
To guarantee the safe functioning of the
3B NETlog™ equipment, it is necessary to
abide by the following instructions:
• Do not connect the 3B NETlog™ device to
a voltage in excess of ±20V or current in
excess of ±2A.
• Make sure the 3B NETlog™ device does
not come into contact with water.
• The 3B NETlog™ device should not be
exposed to temperatures above 80°C.
The operating voltage input is protected
against polarity reversal. However, it is not
protected against excess voltage.
• Do not apply voltage in excess of 4.5V to
the operating voltage input.
2. Scope of delivery
1 3B NETlog™ device
1 Power supply unit (4.5V DC, 300mA)
1 USB cable
1 Installation CD
®
PHYSICS
3B Netlog™
1
3. Introduction
3B NETlog™ is a multimedia data acquisition
and evaluation system for current and voltage
measurements and for measurements using
sensors. The system can be used with or with-
out being connected to a computer. With the
accompanying 3B NETlab™ software, meas-
urements can be conducted with arbitrarily
chosen parameters as well as in prepared
experiments. The prepared experiments take
the user through an interactive experimental
environment where the measurement parame-
ters have already been defined. When used
within a network, the teacher and students can
mutually monitor their results.
Without being connected to a computer, the
3B NETlog™ device can be used as a digital
multimeter for current and voltage measure-
ments. Combined with different sensors, the
3B NETlog™ equipment can also be used as a
handheld unit with automatic sensor recogni-
tion.