Advertisement
Quick Links
You will need ...
Tip:
These speakers are designed for simple DIY installation. If unsure
any handyman, electrician or professional installer can assist.
Location:
For Stereo use: 1.2 meters apart is minimum required for Stereo Separation and 1.2 ~
4.0 meters apart is ideal. Tweeter direction is adjustable to allow for compromised and
less than ideal placement. EHT-8 is the perfect outdoor model due to ample Bass
therefore not requiring Subwoofer.
For Home Theatre use: Sound array from EHT-2, EHT-6 and EHT-8 is downwards
therefore should locate roughly overhead of Listening area. EHT-4 however, is angled at
40 degrees and sound array is downward AND forward thus creating a wide sound array
and larger sweet spot. Ideal for open plan areas.
Advanced Planning is key:
Advance planning in regards to placement of your speakers is critical:
Ensure desired cutout location has available cavity (see above table). If unsure, drill
2mm pilot hole and insert coat hanger wire (or similar) to determine this.
Cutout location must be free of ceiling joists etc. If unsure, Stud Finders are perfect to
determine this. Cutout location must be min. 25mm from a joist/stud for dog-clamp
fixings to swing and clamp rear of gyprock/plaster.
If unsure any handyman, electrician or professional installer can assist here.
D.I.Y In-Wall Installation:
EHT-2, EHT-4, EHT-6, EHT-8
Wall cutting Template
(Supplied)
Stud Finder
(not supplied)
Gyprock/ Plaster
cutting tool
(not supplied)
Philips screw driver
(not supplied)
Ceiling Cavity needed ...
...
EHT-2
EHT-4
EHT-6
EHT-8
100mm
135mm
80mm
95mm
Advertisement
Summary of Contents for Jensen Speakers EHT-2
- Page 1 EHT-8 is the perfect outdoor model due to ample Bass therefore not requiring Subwoofer. For Home Theatre use: Sound array from EHT-2, EHT-6 and EHT-8 is downwards therefore should locate roughly overhead of Listening area. EHT-4 however, is angled at 40 degrees and sound array is downward AND forward thus creating a wide sound array and larger sweet spot.
- Page 2 Using Template (supplied) Use the supplied template trace along perforated line. Ensure your markings are level. Cutting the Wall: Using the appropriate wall-cutting tool, blade or Stanley knife, accurately cut the hole in the ceiling Gyprock/Plaster. Once cut-out complete, remove any insulation from this area only.
-
Page 3: Mounting Speakers
Mounting Speakers: Remove any insulation completely away from Speaker area. Insulation elsewhere is fine. Insert speaker into hole ensuring Speaker wire is away from back of cone to avoid a possible rattle. Using Phillips head screwdriver, tighten 9~10 the 4 or 6 dog-clamp screws until you full turns...