Summary of Contents for Phonak Advanced Bionics Naida CI Q70
Page 1
Fitting Guide Roger and Cochlear Implants This guide provides detailed information on how Roger should be used with the most popular cochlear implant sound processors to achieve the best possible performance. A recent study by Dr. Jace Wolfe of Hearts for Hearing Foundation, Oklahoma City, revealed that the use of Roger systems in combination with cochlear implants resulted in significant improvements in speech recognition at high noise levels (70 to 80 dB (A)) over fixed gain FM and Dynamic FM technologies (see www.phonakpro.com) Set-up...
Pre-fitting Program the sound processor with the recommended settings according to the table below. This will ensure maximum benefit from the Roger system. Model Recommended sound processor setting Set the Audio Mixing Ratio (Mic/Aux) to 50/50 AB Naída CI Q70 Set the ComPilot Mixing Ratio to either 50 or 75% AB Naída CI Q70 via ComPilot Set the Audio Mixing Ratio (Mic/Aux) to 50/50...
Troubleshooting Most probable cause Solution Signal from Roger microphone cannot be heard Sound processor is set in the wrong program Switch the sound processor to the dedicated DAI, EXT ComPilot or AUX program Roger receiver is not connected to the Roger microphone Connect Roger receiver with the Roger microphone (see Step 3) Roger microphone is not switched on or is muted Switch on the Roger microphone and make sure it is not muted...
This manual is also suitable for:
Cp910Advanced bionics auriaCochlear nucleus 6Advanced bionics harmonyCochlear nucleus 5Cp810...
Show all
Med-el opus 2Roger 17Compilot + roger xRoger 14Iconnect + roger xEuro accessory adapter + roger xFm battery door + roger x