Advertisement
Quick Links
Fitting Guide
Roger and Cochlear Implants
This guide provides detailed information on how Roger should be used with the most popular cochlear implant sound processors to
achieve the best possible performance.
A recent study by Dr. Jace Wolfe of Hearts for Hearing Foundation, Oklahoma City, revealed that the use of Roger systems in
combination with cochlear implants resulted in significant improvements in speech recognition at high noise levels (70 to 80 dB (A))
over fixed gain FM and Dynamic FM technologies (see www.phonakpro.com)
Set-up
The table below shows what Roger receiver and/or adapter is required to use Roger with a sound processor.
Advanced Bionics
Naída CI Q70
2
Roger 17
or
ComPilot + Roger X
Roger X is not compatible with the Advanced Bionics (AB) Neptune™ sound processor.
1
Jace Wolfe (2013), Evaluation of speech recognition of cochlear implant recipients using a personal digital adaptive radio
frequency system. Accepted by the
2
TM
PowerCel
170 battery required.
3
Roger X with SN > 1336NY560 only.
4
Build Standard C or higher
. . . .
Advanced Bionics
Harmony™ / Auria™
3
iConnect™ + Roger X
Journal of the American Academy of Audiology.
1
.
Product name
Cochlear
Nucleus 6 (CP910) /
Nucleus 5 (CP810)
Roger 14 or Euro accessory
adapter + Roger X
Receiver + Adapter
MED-EL
OPUS 2
4
FM battery door + Roger X
Advertisement
Related Manuals for Phonak Advanced Bionics Naida CI Q70
Summary of Contents for Phonak Advanced Bionics Naida CI Q70
- Page 1 Fitting Guide Roger and Cochlear Implants This guide provides detailed information on how Roger should be used with the most popular cochlear implant sound processors to achieve the best possible performance. A recent study by Dr. Jace Wolfe of Hearts for Hearing Foundation, Oklahoma City, revealed that the use of Roger systems in combination with cochlear implants resulted in significant improvements in speech recognition at high noise levels (70 to 80 dB (A)) over fixed gain FM and Dynamic FM technologies (see www.phonakpro.com) Set-up...
-
Page 2: Getting Started
Pre-fitting Program the sound processor with the recommended settings according to the table below. This will ensure maximum benefit from the Roger system. Model Recommended sound processor setting Set the Audio Mixing Ratio (Mic/Aux) to 50/50 AB Naída CI Q70 Set the ComPilot Mixing Ratio to either 50 or 75% AB Naída CI Q70 via ComPilot Set the Audio Mixing Ratio (Mic/Aux) to 50/50... -
Page 3: Troubleshooting
Troubleshooting Most probable cause Solution Signal from Roger microphone cannot be heard Sound processor is set in the wrong program Switch the sound processor to the dedicated DAI, EXT ComPilot or AUX program Roger receiver is not connected to the Roger microphone Connect Roger receiver with the Roger microphone (see Step 3) Roger microphone is not switched on or is muted Switch on the Roger microphone and make sure it is not muted...