Xezo SL-3136 S Manual

Thank you for choosing a time-piece from our 925 Sterling Silver collection
(Series: SL-3136S, SL-3136 RG, 2121 SB, 2121 SS, 2121 RG, 2024 SR).
Your watch is fitted with Swiss-made ETA 2836-2 Automatic movement and an
Incabloc® shock-absorber device. The inner mechanism of the watch has a free swinging
rotor that keeps the mainspring wound via the motion of your wrist. A watch fitted with
an automatic winding movement is rewound by the regular movements of your wrist.
Once fully wound, your watch will continue to keep time for approximately 38 hours after
removing it from your wrist. Beyond this time, the watch will stop. You will then need to
rewind it manually turning the crown (A) clockwise(approximately 20 turns) to provide it
with the necessary power reserve. After that, your daily activity should wind the watch
sufficiently to keep it running at night when it is not being worn. You should wear your
watch everyday to ensure optimal rewinding.
Note: As this is a mechanical watch, quartz watch accuracy cannot be expected.
Setting the Time and Date
Setting the Time and Date
Important note:
Do not change the date between 8 p.m. and 2 a.m. as this may
damage the movement. This is when the pinions are being repositioned
to carry out the automatic date change.
1.
Pull out the crown (A) to Position "2" (one "click" out). Rotate the crown (A) clockwise
until the date shows one day earlier than the date you want to set.
Rotate the crown (A) counter-clockwise until the day shows one day earlier than the day
you want to set.
Pull out the crown (A) to Position "3" (two "clicks" out). The seconds hand is stopped.
Set the time by turning the crown (A) counter-clockwise to move the hour and
minute hands forward Turn the watch hands past 12 once if you're setting the watch for a
.
P.M. time.
2.
Once you have set the time or date, return the crown (A) to the pushed down
Position "1" by pressing it against the case.