Table of Contents
Advertisement
Quick Links
Read all Instructions before
Do not use or mix any other manufacturer's products with any Nitrous Express products.
Do not use or mix any Nitrous Express products with any other manufacturer's products.
THESE INSTRUCTIONS APPLY TO NITROUS EXPRESS PRODUCTS ONLY!
FOR SANCTIONED RACE USE ONLY - NOT FOR SALE OR USE IN CALIFORNIA
Nitrous Express Speed3000 R/C Vehicle Nitrous System
The nitrous bottle is shipped empty and must be filled before the system can be used. The
bottle capacity is 4oz
Removal of the body and partial disassembly of your r/c vehicle may be necessary to access all
electronics and to complete the nitrous installation.
1. Find the best and most secure location for the 9v battery to be mounted. This
location needs to be easily accessible, yet protected from possible damage while you
are operating the vehicle.
2. Turn on your transmitter and your receiver and then go to full throttle. Place the
micro switch so that the servo arm activates the micro switch. Mark this location,
then drill and mount the micro switch.
beginning!!!!
Caution – EXTREME DANGER – Caution
Installation Instructions
Advertisement
Table of Contents
Summary of Contents for Nitrous Express Speed3000
- Page 1 Caution – EXTREME DANGER – Caution Do not use or mix any other manufacturer’s products with any Nitrous Express products. Do not use or mix any Nitrous Express products with any other manufacturer’s products. THESE INSTRUCTIONS APPLY TO NITROUS EXPRESS PRODUCTS ONLY!
- Page 2 3. Now you will need to choose a location for a master arming switch. This can be anywhere that is easily accessible and so that it does not interfere with any mechanical linkages 4. Install the .009 jet into the push-to-connect jet fitting and thread into solenoid outlet port.
- Page 3 6. Install the 1/8 poly line into the push-to-connect fitting previously installed in the nitrous solenoid outlet port and route the line into the air filter. The hose should discharge toward the air filter but should not be inserted directly into it. Secure the line with zip ties.
- Page 4 nitrous solenoid should click as the throttle linkage causes the micro switch to be engaged. 9. Once all steps are completed be sure all fittings, nuts and bolts are tight. Re-install any covers or clips that were removed during the installation process. 10.
Need help?
Do you have a question about the Speed3000 and is the answer not in the manual?
Questions and answers