Download Print this page

LAZER Classic Series Owner's Manual & Installation Instructions

Powder coated/stainless steel

Advertisement

Quick Links

WARRANTY
In addition to your legal rights, Rheem New Zealand Limited makes the following promise to the owner. We
will repair or, if necessary, replace a defective boiling water unit or part of it, which has failed due to faulty
manufacture on the following terms and conditions:
WARRANTY PERIOD
AGE OF BOILING WATER UNIT
WARRANTY COVERS ALL BOILING WATER UNITS DOMESTIC,
FROM THE DATE OF INSTALLATION
Up to (1) year
Free replacement of failed component, or if necessary, replacement of
the Boiling Water Unit, free of charge, including labour.**
More than (1) year
Where an inner tank fails it will be supplied free of charge, installation
but less than (5) years
and labour cost will be charged to the owner.
Should your boiling water unit need service under warranty, please call RHEEM SERVICE on
0800 657 335 or refer to the yellow pages under Water Heaters for your nearest local service agent.
WARRANTY CONDITIONS:
1.The Boiling Water Unit must be installed in accordance with the installation instructions, supplied with the
Boiling Water Unit, the NZ Building Code, NZ Electrical Regulations and all relevant statutory requirements
of the area in which the Boiling Water Unit is to be installed.
2.Where a failed component or Boiling Water Unit is replaced under Warranty, the balance of the original Warranty
Period will remain effective. The replaced part or Boiling Water Unit does not carry a new Warranty.
3.Where the Boiling Water Unit is installed outside the boundaries of a metropolitan area as defined by
Rheem New Zealand Ltd, or beyond 25 km from a regional Rheem branch office, or a Rheem Authorised
Service Centre, the cost of transport, insurance and travelling costs between the nearest Rheem Authorised
Service Centre's premises and the installed site will be for the account of the owner.
4.The Warranty only applies to the Boiling Water Unit and therefore does not cover any plumbing or electrical
parts supplied by the installer and not an integral part of the Boiling Water Unit, e.g. pressure limiting valve,
stop cock, electrical switches, pumps or fuses.
WARRANTY INFORMATION
WARRANTY EXCLUSIONS:
REPAIR AND REPLACEMENT WORK WILL BE CARRIED OUT AS PER THE RHEEM WARRANTY (ABOVE),
HOWEVER THE FOLLOWING EXCLUSIONS MAY CAUSE THE BOILING WATER UNIT WARRANTY TO
BECOME VOID, AND MAY INCUR A CHARGE FOR SERVICE AND COST OF REPLACED PARTS.
1. Accidental damage; Acts of God; failure due to misuse; incorrect installation, attempts to repair the unit other
than by a Rheem Authorised Service Agent, or the Rheem Service Department.
2. Where it is found that there is nothing wrong with the boiling water unit; where the complaint is related to low
or high water pressure; where there is no flow of hot water due to faulty plumbing or a blocked filter; where
water leaks are related to plumbing work and not the boiling water unit or its components, where there is a
failure of electricity or water supplies.
3. Where the boiling water unit or its component has failed directly or indirectly as a result of high water
pressure.
4. Where the boiling water unit is located in a position that does not comply with the Rheem installation
instructions or relevant statutory requirements causing the need for major dismantling or removal of
cupboards.
5. Subject to any statutory provisions to the contrary claims for damage to furniture, carpets, walls, foundations,
or any other consequential loss either directly or indirectly due to leakage from a boiling water unit.
6. Repairs to the boiling water unit due to scale formation in the waterways when the heater has been
connected to a harmful water supply as outlined in the owners guide.
RHEEM SERVICE DEPARTMENT
Contact details:
475, Rosebank Road, Avondale, Auckland
Phone: 0800 657 335; Fax: 0800 657 337
12.
COMMERCIAL OR INDUSTRIAL
** Refer to item 3, Warranty Conditions.
CONSTANT BOILING WATER
OWNERS GUIDE
INSTALLATION INSTRUCTIONS
CLASSIC SERIES
POWDER COATED
Models 3, 5, 7.5, 10, 15, 25, & 40 Litre
IMPORTANT, PLEASE LEAVE WITH THE OWNER
Part No. 316935D
&
/
STAINLESS STEEL

Advertisement

loading

Summary of Contents for LAZER Classic Series

  • Page 1 0800 657 335 or refer to the yellow pages under Water Heaters for your nearest local service agent. WARRANTY CONDITIONS: 1.The Boiling Water Unit must be installed in accordance with the installation instructions, supplied with the CLASSIC SERIES Boiling Water Unit, the NZ Building Code, NZ Electrical Regulations and all relevant statutory requirements POWDER COATED STAINLESS STEEL of the area in which the Boiling Water Unit is to be installed.
  • Page 2 CONTENTS PRODUCT ERROR CODES 1. WARNING ...................... 3 Error Code 2. WATER QUALITY ..................3 Hot Thermistor Fault – O/C, S/C Heating Triac S/C – uncontrolled temperature rise 3. INSTALLATION ....................3 Expired Filter A. Location ....................3 Calibration Time Out B.
  • Page 3: Water Quality

    “Keypad locked” message will display prevent tampering with unit on screen every time a timer button is Thank you for choosing our Lazer Boiling C. MINIMUM CLEARANCES settings. Default setting is disabled. pressed. Water Unit. Please take a few minutes to (Prog>Keypad Lock>Accept)
  • Page 4: Overflow / Vent Connection Importance

    Connect a 15 mm (½”) pipe to the more than 1 metre of head on the Lazer boiling “Sleep Delay Time” period. The screen Boiling Unit Display Temp overflow/vent connection (½”BSP nipple).
  • Page 5: Operation

    Press the (UP) button until the desired Approx Approx. time to button to confirm selection. Lazer. If the supply cord of this unit is Lazer Size Recovery heat full Capacity day appears on the screen and press the...
  • Page 6: Dimension Specification

    DIMENSION SPECIFICATION Classic Figure 2: Overflow / Vent Connection MOUNTING DIMENSION SPECIFICATION All models models Figure 4: Dimension Specification 3 Litre 5 Litre 7.5 Litre 10 Litre 15 Litre 25 Litre 40 Litre Dimension A mm B mm C mm Figure 3: Mounting Dimension Specifications D mm E mm...

This manual is also suitable for:

Classic 3 litreClassic 5 litreClassic 10 litreClassic 7 litreClassic 25 litreClassic 15 litre ... Show all