Download Print this page

Garelick Model-90 Installation Instructions

Detachable pedestal plate, swivel stanchion foot rest

Advertisement

Quick Links

SEAT BASE INSTRUCTIONS
Refer to Fig. 1
1. Attach swivel casting (A) to seat bottom.
FOR EEZ-IN SEATS WITH PREDRILLED, T-NUTTED HOLES:
Align holes in both swivel casting and seat bottom.
Secure in position with four 1/4-20x1" machine screws.
FOR SEATS WITHOUT T-NUTTED HOLES:
Center swivel casting on seat bottom. Mark and drill the
four holes for the swivel on the seat. Use an expansion
type fastener (i.e. expansion screw anchor, etc.) best
suited for boat seat's construction to secure swivel casting
to seat.
NOTE: Fasteners NOT Provided.
2. Grease the inside of the swivel casting.
3. Screw in locking knob (B).
4. Secure seat base (C) to boat deck. This deck area should
be adequately reinforced. Use a backing plate if necessary
to make a secure attachment. It is recommended that the
fasteners used go through both deck and backing plate for
best results (see illustration). Six holes are drilled in the
base for attachment but fasteners are NOT provided for
this application as the type needed may vary. (NOTE: If
mounting a seat base with a detachable pedestal plate,
follow the Model-90 mounting instructions below before
proceeding.)
5. Place seat with swivel casting on stanchion tube (D) and
secure in position with locking knob (B).
6. Polish aluminum to extend longevity.
99300 INSTALLATION INSTRUCTIONS
Refer to Fig. 2
1. Loosen locking knob and remove seat from pedestal.
2. Slip lock ring 06.483 over pedestal and slide down tube
approximately 4". Insert 8-32 x 1" screw and secure lightly
with 8-32 locknut.
3. Slip seat onto the pedestal. Place lock 06.484 over lock
ring and slide assembly up so that the lock slides into the
rectangular opening in the casting directly below the
locking knob. Secure with 10-24 x 1-3/4" screw and
10-24 locknut.
4. Tighten 8-32 screw and locknut to secure lock ring.
To remove seat reverse steps 3 and 4.
Write for
a Complete
Catalog
Instructions for
Seat Bases,
Model-90 or Model 75056 Detachable Pedestal Plate,
and Model 75004 Swivel Stanchion Foot Rest
(OVER)
PO Box 8, 644 2nd Street
St. Paul Park, Minnesota 55071
FIG. 1
FIG. 2
On the Web: www.garelick.com
Form 12.146
Phone: 651-459-9795
E-mail: mail@garelick.com
1/03

Advertisement

loading

Summary of Contents for Garelick Model-90

  • Page 1 Form 12.146 Instructions for Seat Bases, Model-90 or Model 75056 Detachable Pedestal Plate, and Model 75004 Swivel Stanchion Foot Rest SEAT BASE INSTRUCTIONS FIG. 1 Refer to Fig. 1 1. Attach swivel casting (A) to seat bottom. FOR EEZ-IN SEATS WITH PREDRILLED, T-NUTTED HOLES: Align holes in both swivel casting and seat bottom.
  • Page 2 Form 12.146 Assembly Instructions – Seat Bases, Model-90 or Model 75056 Detachable Pedestal Plate, and Model 75004 Swivel Stanchion Foot Rest MODEL-90 DETACHABLE PEDESTAL PLATE INSTRUCTIONS MODEL 75004 SWIVEL STANCHION FOOT REST INSTRUCTIONS Refer to Fig. 3 Refer to Fig. 4 1.

This manual is also suitable for:

7505675004