B+B SmartWorx ABDN-SE-DP551 Quick Start Manual

(Continued)
CLI commands let you request status or change
parameter settings. A full list of commands is
provided on your software CD. You can also
download this information at www.advantech-bb.com
If you have questions, visit our Knowledge Base at
www.advantech-bb.com
5

Troubleshooting

To Do A Factory Reset: Apply power while you have the
Reset button held in. Hold the Reset button and release
after 10 seconds.
After Initial Configuration: If you have an Amber "Power"
LED and a Red "Link" LED combination, please verify that
the SSID and security are correct. These parameters are
case sensitive.
LED COLOR AIRBORNE DEVICE STATE
Off
Adapter is not powered.
Red
Adapter failed Power On Self Test (POST).
POWER
Adapter passed POST but is not configured for wireless network
Amber
communication.
Adapter passed POST and is configured for wireless communica-
Green
tion.
Off
Adapter is not powered.
(Periodic Blinking) Adapter is searching for a valid network (Access
LINK Red Off
Point) that matches device's configuration.
Green
Adapter has successfully associated with an Access Point.
If Power LED is also Off, then Adapter is not powered.
If Power LED is On, then either:
Off
• A physical connection detected on Serial/Ethernet cable.
• No TCP session from wireless interface has been established.
Red
No physical Serial/Ethernet connection has been detected.
(Blinking – OFF/Red) A physical Serial/Ethernet connection has
been detected and there is traffic across the interface.
Red Off
No TCP connection to the adapter has been established on the
wireless interface.
COMM
A TCP connection to the adapter from the wireless interface has
Amber
been established but no physical connection on the Serial/Ethernet
interface has been detected.
(Blinking – Green/Orange)
A physical Serial/Ethernet connection has been detected and there
Green Amber
is Serial/Ethernet traffic across the interface. A TCP connection to
the adapter has been established (On WLAN or Ethernet interface).
A physical Serial/Ethernet connection has been detected. A TCP
Green
connection to the adapter has been established from the WLAN or
Ethernet interface but no traffic has been detected.
Please see the Knowledge Base on the B+B SmartWorx
website if you run into any issues while trying to follow
this guide.
Document Number: 710-10225-00_R3_ABDN-SE-DP55x_1017qsg
Recommended Accessories
Null Modem Cable
Model 232NM9FF3
802.11 Wireless Router,
Access Point & Serial
Device Server
Model APXN-Q5420
1-888-948-2248 | Europe: +353 91 792444
advantech-bb.com
707 Dayton Road | PO Box 1040 | Ottawa, IL 61350
Phone: 815-433-5100 | Fax: 815-433-5109
www.advantech-bb.com | E-mail: support@advantech-bb.com

QUICK START

GUIDE
ABDN-SE-DP551 &
ABDN-SE-DP553
Wireless Serial Adapter
Before you begin, be
sure you have the following:
+ ABDN-SE-DP551 or ABDN-SE-DP553
+ 5 VDC Power Supply, 2.1 mm barrel jack
(included)
+ Dual Band 2dBi RP-SMA Antenna
(included)
+ Software CD (included)
www.advantech-bb.com
Fast and easy on the web: