8000
SpO
Soft Sensors
2
Use only with compatible nonin Medical pulse oximeter monitors.
1. Select the proper size sensor.*
Large 8000SL
Medium 8000SM
Small 8000SS
2. Use clean, dry finger where sensor will
be placed. Heavy lotions, sunscreen, dirt, oils
and nail polish may alter accuracy.
3. Gently squeeze the sides to open
the sensor.
4. Slide onto the finger to the end of the
sensor with cable on top of hand. Place
finger tip at – but not pushed through –
the end of sensor. Check that sensor gently
hugs finger and is not too tight
or too loose.
5. Secure sensor to back of hand with
medical tape to allow movement.
6. Connect to a Nonin pulse oximeter. Follow
instructions in oximeter Operator's Manual to
measure oxygen saturation and pulse rate.
* Sizing is for reference only. Fit, patient comfort and signal quality should be used to determine appropriate size/model.
0.5 – 1 inch (12.5 – 25.5 mm)
0.4 – 0.75 inch (10 – 19 mm)
0.3 – 0.5 inch (7.5 – 12.5 mm)
quick guide
mm
inch
25.5
1
19.12
.75
12.75
.5
6.36
.25
0
0
Actual size
3
4
5
=