Kohler 72704-4 Installation Instructions

OPERATION INSTRUCTIONS
Lift the handle slightly to turn on the faucet. Turn to vertical position for cold water, horizontal position for hot
water. Water flows out from spout when faucet diverter is in the normal position and it's diverted to shower
column when the diverter knob is lifted.
Turn the diverter handle to the vertical upwards, water will flow from the handspray; turn it to the vertical
downwards, the showerhead will work; turn it to the position between the vertical upwards and the vertical
downwards, water will flow the showerhead and the handspray.
INSTALLATION CHECKOUT
Ensure that all connections are tight. Ensure that the handle is in the
off position.
Turn on the drain and main water supply, and check for leaks. Repair
as needed.
Remove the aerator assembly(34). Run hot and cold water through
spout about one minute to remove any debris. Clean the aerator
assembly. Shut off the faucet. Reinstall the aerator assembly.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean
soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
1124477-2A-G
INSTALLATION INSTRUCTIONS
12959-4
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co.
reserves the right to make changes in product characteristics, packaging, or availability at any time without
notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Shut off the water supplies to the fitting.
2. Inspect the supply tubing for damage. Replace as necessary.
3. Observe local plumbing codes.
4. The minimum inlet water pressure for diverter is 0.05MPa(0.5bar).
5. Recommended minimum working pressures is 1bar(0.1Mpa).
6. The highest working pressure for showerhead & handspray is 0.5MPa(5bar). If it exceeds 0.5MPa(5bar), a
34
pressure reducer is needed. The highest water and environment temperature is 60°C. Please keep
handspray showerhead and the shower arm away from heater, or it may become damaged and cause injury
to the user.
ROUGH-IN DIMENSIONS
G1/2˝
Finished Floor
4 1124477-2A-G
Wall-Mount Bath & Dual Shower Faucet
72704-4 Wall-Mount Bath & Dual Shower Faucet
400
Ø145
62
66
155
Four-way Handspray
(Only for 12959-4)
34
49
G1/2˝
60
61 150
G1/2˝
19
Ø102
G1/2˝
71
Only for 72704-4
G1/2˝
G1/2˝
G1/2˝
G1/2˝
1