Advertisement
Quick Links
Overview
This document summarizes introductions for operating hub IT-RFHUB-01 and in-wall switch IT-RFSWITCH-01. Working as a paired set, IT-RFHUB-01
and IT-RFSWITCH-01 can remotely control the QuietCool Whole House Fans of QC Manufacturing Inc at up to three different speeds.
Key Specifications
IT-RFHUB-01 (Hub):
Voltage: 120V
Frequency: 60Hz
Motor load: 1HP, 735W (Max)
Warning:
- Disconnect power at the circuit breaker
before installing or servicing
- Use wires rated at least 105*C – copper
only
FCC Regulations
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Statement:
"This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help."
FCC Caution:
Changes or modifications not expressly approved by the part responsible for compliance could void the user's authority to operate the equipment.
IT-RFSWITCH-01 Wall Switch & IT-RFHUB-01 Hub
Installation Guide
IT-RFSWITCH-01 (Switch):
Voltage: 3VDC (2 AAA batteries)
Battery Standby Current: ≤10uA
RF working distance: 100ft (no obstructions)
- Installation/wiring must be in accordance
with national and local code regulations
- Keep the enclosure cover closed at all
times when not servicing.
- Cover all unused wires with a wire
connector
Rev 1.0
Page 1 of 4
Advertisement
Related Manuals for QuietCool IT-RFSWITCH-01
Summary of Contents for QuietCool IT-RFSWITCH-01
-
Page 1: Installation Guide
This document summarizes introductions for operating hub IT-RFHUB-01 and in-wall switch IT-RFSWITCH-01. Working as a paired set, IT-RFHUB-01 and IT-RFSWITCH-01 can remotely control the QuietCool Whole House Fans of QC Manufacturing Inc at up to three different speeds. Key Specifications... - Page 2 Installation Fig. 1 Install Battery onto In—wall Switch In-wall Switch: The in-wall switch is a standard decora style wall switch which can be fitted into a standard wall box or onto a wall- mount base plate that comes with the switch. As shown in Fig.
- Page 3 Operation Power on the Hub: Switch on power to the hub, the Power indicator on the hub will be on, and other three indicators will stay off. Press the “Test” button to change fan speed, the fan will run in the following cycles: 1 speed fan: on ->...
- Page 4 If only one of the timer LEDs is on and only one of the speed LEDs is on after pressing either button Fig. 6 Front Panel LEDs for Status Reporting in sleep mode, the hub is running the motor at the set speed and the timer is in the set delay-off state. If all the timer LEDs are on and only one of the speed LEDs is on after pressing either button in sleep mode, the hub is running the motor continuously at the set speed.