Wifi - internet radio/dab+/fm rds stereo receiver (48 pages)
Summary of Contents for Sangean DDR-22
Page 1
ELECTRIC SHOCK, DO NOT REMOVE WARNING SIGN ALERTING THE BACK, NO USER SERVICEABLE YOU OF IMPORTANT PARTS INSIDE. REFER SERVICING TO INSTRUCTIONS ACCOMPANYING QUALIFIED SERVICE PERSONNEL. THIS RADIO. Please read this manual before use 2006/4/14, ¤U¤È 04:42 DDR-22 DAB+FM/RDS+MW Operating instruction...
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Remote control Note: Remote control unit is designed to suit for CD and also non-CD version of radio. Some buttons will be useless for non-CD version. 1. Standby button 2. Sleep button 3. Mode Selection 4. Audio Mute 5. Volume Control 6.
Remote handset battery replacement 1. Release battery holder locker by pressing the holder up. 2. Pull out the battery holder. 3. Replace supplied battery (CR2025 or equivalent) ensuring that positive side of battery faces you with holder positioned. 4. Replace the battery holder and make sure the holder locker is in right position.
Time setting 1. Turn on the radio by pressing standby button. 2. Press and release MODE button, display will flash 0:00. 3. Press and release Time Set button , display hour digit will flash. 4. Press Tuning +/- button to select required hour then press Time Set button again to confirm hour setting.
Alarm time setting 1. Press Mode button will cycle through Normal display, clock display, alarm on display , Alarm off display, Alarm source, Alarm volume, Sleep and normal display again. 2. During Alarm on display status, press Time Set button display hour digit will flash.
Alarm off time setting Follow above alarm on time setting to set alarm off time. Alarm Source 1. Pressing Mode button to select Alarm Source mode. 2. Press Adj. button, display will flash last alarm source set. 3. Press Tuning + /- button to select required alarm source. 2006/3/23, ¤W¤È...
Alarm Volume 1. Pressing Mode button to select Alarm Volume mode. 2. Press Adj. Button, display will flash last alarm volume set. 3. Press Tuning +/- button to select required alarm volume. Alarm on and off 1. Press ALARM button will toggle the alarm timer enable or disable. 2.
Sleep setting 1. Press and release Sleep button to select required radio auto off time. 2. Release Sleep button when required sleep time is reached. 3.To check remaining Sleep timer time. Press and release Mode button to select Sleep mode. DDR-22_381P101_GB.p65 2006/3/23, ¤W¤È...
Operation radio Note: other than the volume control and standby on/off. All the operation of this receiver is via supplied remote control unit. Operating your radio – DAB 1. Fully extend the telescopic aerial. 2. Press the Standby button to switch on your radio then press DAB. Display will show “Welcome to Digital Radio“...
Selecting a station – DAB 1. The top line of the display shows the name of the station currently selected. 2. Press the Tuning + or Tuning – button to scroll through the list of available stations. Stop pressing the Tuning buttons when you find the station you wish to hear.
Auto tuning As time passes, new station may become available. To find new stations, proceed as follows: a. Press and release Auto Tune button, display will show “Scanning“. Your radio will perform a scan of the DAB channels. As new stations are found, the station counter on the right-hand side of the display will increase and stations will be added to the list.
Normal display mode Your radio have several display modes. Press the INFO button to cycle through the various modes. a. Scrolling text Displays scrolling text messages, such as artist/track name, phone in number, etc. b. Program type Displays type of station being listened to e.g.
Advanced display mode a. Press and release SETUP button to view technical information on the currently selected services and select lower level menu options to configure the DAB receiver. b. Press Tune +/- button to scroll through the options: Station order Manual tune DRC value Sw version...
Station order – Service list order 1. In Station order mode, the user will be presented with a menu. The top line will contain currently selected service list order. The bottom line will contain the selected service mode with scrolling indicators. 2.
Manual Tuning 1. In the Manual Tuning mode, press OK then tuning +/- button to scroll through the band III options: 5A 174.92 MHz 5B 176.64 MHz 13E 237.48 MHz 13F 239.20 MHz 5A 174.92 MHz. 2. Press OK button to select the stations. 3.
DRC Value Control 1. In DRC value mode, the user will be presented with a menu. The top line will contain the currently selected DRC value. The bottom line will contain the first value in the list, with scrolling indicators. 2.
Factory RESET If your radio fails to operate correctly or some digits on the display are missing or incomplete carry out. Carry out following procedures. 1. Press and release SETUP button then tuning +/- button to scroll through the options until Factory reset shown on the display. 2.
Operating the radio – FM band 1. Fully extend the telescopic aerial. 2. Press Standby button to switch on the radio. 3. Press the Band button to select the FM band. 4. Press and release Tuning control +/- button to tune to required stations.
Display modes – FM RDS Your radio has four display mode in FM band: The Radio Data System (RDS) is a system in which inaudible digital information is transmitted in addition to the normal FM radio program. RDS offers several useful features. The following are available on your radio.
Search RDS program type Press Auto Tune/RDS PTY to cycle through program type e.g. Pop, Classic, News, etc. and then press Tuning +/- button to search up/ down the frequency, the search processing will stop once the station meet demanding program type. 2006/3/23, ¤W¤È...
Operating the radio – MW band 1. Press the Standby button to switch on the radio. 2. Press the band button to select MW band. 3. Press and release Tuning Control +/- button to tune to required stations. Long press Tuning Control +/- button for more than 0.7 seconds, radio frequency will automatically increase/decrease until next station of sufficient strength has been found.
DAB band Preset station 1. Press Standby button to switch on the radio, then press DAB button to tune required station as previously described. 2. Press and hold down the required Preset button (1-10) until display show e.g. “Preset 1 saved“. The station will be stored under the chosen preset station.
Recalling DAB preset station 1. Press the Standby button to switch on the radio. Press DAB button to select DAB waveband. 2. Momentarily press the required Preset button, your radio will tune to the station stored in preset memory. DDR-22_381P101_GB.p65 2006/3/23, ¤W¤È...
FM/MW waveband preset station 1. Press the Standby button to switch on the radio, press Band button to select FM or MW band and tune to a station as previously described. 2. Same as DAB preset station described above. Recalling FM/MW waveband preset station 1.
Preset EQ Press the EQ button to cycle through the preset equalizer mode of Flat Jazz Rock Classic Flat … The initial setting of the equalizer mode is Flat. 2006/3/23, ¤W¤È 09:49 DDR-22_381P101_GB.p65...
Operating the radio – Aux In 1. Connect a stereo or mono audio source (like CD walkman, MP3 player) to Aux In socket on the rear side of the radio. 2. Press the band button to select Aux band. 3. Adjust the volume control for comfort listening. Operating the radio –...
Headphone use Headphone use with this radio should be fitted with a 3.5 mm jack plug. Insert the headphones into the socket marked the rear side of the radio. When the headphones are plugged in, the loudspeaker is automatically disconnected. Flat/3D sound effect Switch the 3D switch (on the rear side of the radio) to get flat or 3D sound effect.
Specifications Power Requirement: AC 230V 50 Hz. Frequency Coverage: DAB Band 3 174.928 – 239.200 MHz FM band 87.50 – 108 MHz MW band 522 – 1710 kHz Loudspeaker: 2.5 inches 8 ohm x 2 Output Power: AC power 5 Watt x 2 If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste.