Advertisement
Quick Links
Professional Ducting Range
Ducting
Rangehood
Installation Guide
:
(Disclaimer) The following instructions are provided as a guide only and in no way constitute or replace your local council requirements or Australian and New Zealand Standards and Building Codes.
Please Note: As shown in Fig.1. – the ducting used is 150mm Ø and dimensions to the point of convergence are based on a 45⁰ roof pitch...
Semi-Rigid duct can bend reasonably sharply without impeding air-flow and as shown in Fig.1. and from the centre of the vent, to the point of
•
convergence is 250mm.
SIRIUS "EASYEAVE 150/200" installation guide
Sirius ducting kits are a high quality and simple, complete solution in a box. They provide an
ideal ventilation path to efficiently exhaust your kitchen fumes, steam, heat and odours –
filtered through your rangehood to the outside atmosphere.
Please check that there is a clear path for your ducting to run prior to installation, making sure
to look out for TV, computer, telephone and electrical cables, water and gas pipes, insulation
materials and air conditioning pipes and duct, before cutting holes.
For new homes, ideally fit the basic ducting (pipe) components at the frame up stage.
Additional lengths of ducting, joins, galvanised steel angled elbows and all other ducting
accessories are available from your local retailer where you purchased your SIRIUS EasyKIT.
For further advice please call our ducting consultation service on Ph: 1300 762 219 (Australia
only) or visit
assist you in the best manner possible.
Eave Vent
Fig.1.
www.siriusbrand.com
and fill in the fields and one of our trained consultants will
.
Advertisement
Summary of Contents for Sirius Satellite Radio EASYEAVE 150
- Page 1 SIRIUS “EASYEAVE 150/200” installation guide Sirius ducting kits are a high quality and simple, complete solution in a box. They provide an ideal ventilation path to efficiently exhaust your kitchen fumes, steam, heat and odours – filtered through your rangehood to the outside atmosphere.
- Page 2 Obviously if there is an increase or decrease in the pitch (angle) of the roof, these measurements will vary slightly… After checking that there is a clear path to run the ducting, check measure the distance from the Vent position in the eaves, back to where the ducting will •...