hager 790-904 Installation Instructions Manual

Installation Instructions HAGER Models: 790-904 and 790-906
Molding
HAGER Models 790-904 and 790-906 are Stainless Steel Continuous Half Edge Mount Hinges for 1-3/4" (44.5mm) thick doors. The
frame face must have a flat surface at least 1-5/8" wide. Clearance required between the hinge edge of the door and the frame rabbet
is 1/8" (3.2mm) minimum. Model 790-906 features an integral protective corner guard and is not recommended for use on doors that
have a beveled edge on the hinge side.
Hinge Length
All HAGER Stainless Steel Continuous Hinges are supplied 7/8" to 1"
shorter than the nominal door height to avoid threshold or carpet
clearance problems. If the hinge must be trimmed shorter, first
determine the correct hand of the door and orientation of the hinge.
Remove the bottom pin cap and trim from the bottom end of the hinge
only to achieve the desired length – do not cut the top end. Undercut
the pin 7/8" shorter for clearance and reinsert the bottom pin cap.
Total Clearance Between Door and Frame Width
1/8"
min.
S D
INGLE OOR
Hinge side clearance (minimum)
Allowance for frame irregularities
Latch side clearance (typical)
For doors that are pre-beveled 1/8"-in-2" on the hinge edge, add 1/32" (0.8mm) per door to the T
*
For Model 790-906, the hinge edge of the door should not be beveled.
General Fitting Procedure

For new construction with metal doors/frames: To accommodate the 1/8" (3.2mm) minimum hinge clearance required for HAGER
Model 790-904 and 790-906, order the door undersized or the frame header oversized. See the clearance information above to
HAGER Companies - 139 Victor Street - St. Louis, MO 63104 (314-772-4400)
790-904
1/8"
1/8"
- S E
QUARE DGED
1/8" (3.2mm)
1/32" (0.8mm)
1/8" (3.2mm)
9/32" (7.1mm)
T *
OTAL
Molding
790-906
N . D
OM OOR
N . H
OM
H
EIGHT
6'-8" 79" (2006mm)
7'-0" 83-1/8" (2111mm)
7'-2" 85" (2159mm)
8'-0" 95" (2413mm)
10'-0" 119" (3022mm)
1/8"
1/8"
min.
P D
AIR OF OORS
Hinge side clearance (minimum)
Allowance for frame irregularities
Clearance between doors (typical)
Second hinge side clearance (minimum)
Second allowance for frame irregularities
clearance shown (Model 790-904 only).
OTAL
Rev. 1/21/08
N F
UMBER OF
L
INGE ENGTH
(Door/Frame)
19 / 13
21 / 14
21 / 14
23 / 15
27 / 18
1/8"
3/16"
min.
- S E
QUARE DGED
1/8"
1/32"
3/16"
1/8"
1/32"
1/2" (12.7mm)
T *
OTAL
Part No.: 75009404
ASTENERS
(3.2mm)
(0.8mm)
(4.8mm)
(3.2mm)
(0.8mm)