LOKAR BAG-6121 Installation Instructions

1964 - 1970 Mustang Brake & Clutch Pad Installation Instructions
Part # BAG-6121, BAG-6123, BAG-6125,
XBAG-6121, XBAG-6123, XBAG-6125
Stop! Please read all installation instructions before
beginning installation.
WARNING: Disconnect the battery before beginning
installation. Make sure the vehicle is in Park and at
least one tire is scotched to prevent the vehicle from
moving.
Mustang Brake & Clutch Pad Installation
Step 1: Remove the stock rubber cover from the clutch or
brake pedal. Photo 1
Step 2: Position the new Lokar aluminum cover on the stock
clutch or brake pad. Make sure pad is set on so that
the lip on the backside of the pedal is even all the
way around the pedal.
Step 3: We recommend using a transfer punch that is 3/16
in diameter to get an accurate punch mark for drill-
ing. Photo 2 Note: If only a center punch is avail-
able, you can use it. However, be sure marks are
centered in the hole.
Step 4: Double check your marks. Remove pad and drill the
steel pad using a 3/16 diameter drill. Photo 3.
Be sure holes are deburred before using supplied
stainless hardware.
Step 5: Set pad back on and use supplied 10/32
countersunk screws and nylocks and attach as seen
in Photo 4. Note: Do not over tighten.
1964 - 1970 Mustang
Part # BAG-6121, BAG-6123, BAG-6125, XBAG-6121, XBAG-6123, XBAG-6125
Step 6: Glue in the end rubber using the supplied 3M™ Glue in
kit. Note: Read glue manufacturer instructions for proper
application. If excess glue gets on aluminum, clean it
off with Goo-Gone™ before glue dries. Photo 5
Photo 1
Photo 4
Brake & Clutch Pad
Step 7: The Lokar pads are now installed and will complement
the Lokar Throttle Pedal Assembly. Photo 6
Photos 1 - 6
Mustang Brake and Clutch Pads
Photo 2
Photo 5
Installation Instructions
Photo 3
Photo 6