San Jamar EZ-Fit Lid L2200C Instruction Manual

EZ-Fit® Lid L2200C
Lid Dispenser Instruction Guide
Thank you for purchasing the EZ-Fit® Lid Dispenser from San Jamar. EZ-Fit® Lid is designed to provide simple, sanitary lid dispensing
that is easy and convenient for both you and your guests. If you have any questions or comments, please do not hesitate to contact us
at www.sanjamar.com or (800) 248-9826.
Note: EZ-Fit® Lid Dispensers are intended for use with flat, cold beverage lids only. This product is not designed for use with domed
lids or most contoured hot beverage lids. For best performance, test lid compatibility prior to installation.
The L2200C EZ-Fit® Lid Dispenser is designed for use with lids up to 3.75" in diameter. For larger lids, please use the L2400C EZ-Fit®
Lid Dispenser.
In-CountEr MountIng InstruCtIons
1. Cut hole in counter surface.
2. Remove trim ring with lid dispenser door assembly
attached by turning counterclockwise.
3. Insert dispenser tube into
counter and secure mount
ring to counter with screws
provided (#8 screws).
4. Replace trim ring with lid dispenser door assembly by
turning clockwise.
5. Rotate lid dispenser door assembly (a) to desired
orientation (b).
a b
LoadIng InstruCtIons
1. Open lid dispenser door by pressing
down on top of door assembly (a) and
pulling outward (b), releasing door latch.
2. Load full sleeve of lids, assuring that inside of lids are facing
outward, as shown.
3. While holding lids in place, close lid
dispenser door, snapping latch securely
in place.
a
b