Pro-Elec LP07816 Installation Instructions

Before starting installation, please read these instructions carefully. Failure to follow them could lead to risk of
injury or electrical shock. Please retain them for your future reference.
Safety Notes

LED lamps are extremely bright. To avoid possible damage to the eyes, do not stare into an LED beam.

In use, avoid touching any external surface of the floodlight, due to the possibility of high temperatures.

The floodlight is suitable for connection to a 220-240V 50Hz, earthed socket outlet.

If the mains cord lead of this floodlight is damaged, it shall be replaced by the manufacturer or his
service agent or a similar qualified person to avoid a hazard.

The floodlight is suitable for use in an ambient temperature of between -20

The floodlight can under no circumstance be mounted on normally flammable surfaces.
Installation
This floodlight is suitable for both indoor and outdoor lighting applications, for domestic use only. It has an IP
rating of IP65. This means that it is dust tight and will prevent the ingress of water from water jets.
Do not use in areas where an explosive or chemical atmosphere may exist. Do not use in areas where
ventilation is restricted.
The floodlight must be positioned so that there is at least 0.5m (500mm) between the front of the floodlight
and the surface to be illuminated.
Ensure that there is space around the floodlight to allow adequate circulation of air.
It is suitable for mounting on plasterboard, wood or masonry surfaces. Highly flammable surfaces such as
plastic or polystyrene must not be used. Do not install on damp or conductive surfaces such as metal. It
should be placed away from any flammable materials.
Before drilling any fixing holes, check that there are no hidden obstructions behind the mounting surface such
as pipes or cables
The recommended height for installation of the floodlight is between 2 and 3
Orientation of the floodlight is important as shown below:
The floodlight can be adjusted upwards and downwards at an angle of 60°. The floodlight has a beam angle of
110°
Ensure that the mains plug is disconnected from the mains socket outlet before commencing installation.
Check that you have all the tools that you need.
1. Check that the floodlight and its mains lead are not damaged. If there is any damage, return it to the
place where you purchased it. Do not attempt to repair it yourself.
2. Choose your location to fix the floodlight, taking into account the comments above
LED Floodlight – Installation Instructions
o o
C and +50 C.
meters.