Page 1
Service & maintenance instructions for gas spring models: CU 1000, CU 1800, CU 2900, CU 4700, CU 7500, CU 11800, CU 18300 T-handles Lock ring tool Valve tool Charging Charging armature adapter Box 216, 573 23 Tranås, Sweden Tel +46 140 571 00, Telefax +46-140-571 99 www.kaller.com...
Page 2
Bottom For more information, also refer to Lock ring the“Instructions for service and maintenance of C)* Back-up ring KALLER Gas Springs”, Part No. 8100-2000. D)* O-ring Tube Disassembly F)* Piston seal with O-ring 1) Clamp the gas spring in a vice (fitted with G)* Wear ring protective jaws).
Page 3
SERVICE INSTRUCTION 6) Remove the piston seal (F) and the guide 15) Clamp the tube with the lock ring groove ring (G) from the piston. facing upwards securely in the vice. Oil the seals on the piston and the upper part of Note! Be careful not to damage the the tube.
Page 4
(Order No. 3415075-2000). G 1/8” charging adapter, 3014016, valid for CU 1800 to CU 18300 21) Check that the evacuating valve (P) and the 25) Open the shut-off valve (Q) slowly on the armature and charge as slowly as shut-off valve (Q) are closed (turn in a clockwise direction).