Vanguard Dynamics COD-401 Owner's Manual

SPECIFICATIONS
FREQUENCY RANGE
HIGH FREQUENCY DRIVER
LOW FREQUENCY DRIVER
SENSITIVITY
POWER HANDLING
IMPEDANCE
ENCLOSURE MATERIAL
ENCLOSURE TYPE
FINISH
PRODUCT DIMENSIONS
PRODUCT WEIGHT
INTRODUCTION
The Vanguard Dynamics COD Series Outdoor Speakers are all-weather loudspeakers that bring an amazing audio experience outdoors. Enjoy great sound
out of a small footprint with drivers tuned to perfec�on. The COD speakers are available in black or white UV treated ABS enclosures along with color
matched aluminum grills.
WIRING
1. A�ach the speaker cables to the speaker cable terminals on the back of the COD speaker.
2. Connect the speaker cable while ensuring proper polarity with the amplifier, + to + (red) and - to - (black).
3. Also ensure that the right channel of the amplifier is connected to the right speaker and the le� channel to the le� speaker.
PLACEMENT
Outdoor Installa�ons
1. When moun�ng the COD speakers outdoors, the eaves of the roof provide an ideal loca�on as they reduce the exposure of constant
direct sunlight and precipita�on.
2. If installing speakers on a boat, the wheelhouse provides the best loca�on for the same reasons.
Indoor Installa�ons
1. When placing the COD speakers on a wall or bookshelf, we recommend that they are mounted at ear level or slightly higher.
2. The usual listening area should be no closer to the speakers than the distance between the speakers themselves.
MOUNTING
1. The COD speaker is supplied with a U shaped wall moun�ng bracket that can be installed ver�cally or horizontally.
2. Use screws, bolts or anchors (not included) that are capable of suppor�ng the weight of the speaker to mount the bracket.
3. Choose a moun�ng surface with sufficient strength to reliably hold the speaker. (See Diagram 1 below)
4. Mount U bracket with slots poin�ng upward if moun�ng horizontally.
5. Once the bracket is securely fastened, insert knob screws loosely on to the speaker and slide on to bracket. (See Diagram 2 below)
6. Rotate the speaker to desired posi�on and �ghten the knob screws.
7. There are two M6 inserts located on the back of the speaker for other types of moun�ng brackets. (Make sure to select a bracket
capable of suppor�ng the weight of the speaker.
COD-401
110Hz - 20kHz +/- 3dB
1/2" PEI Dome Tweeter
4" PP Woofer
88 dB
35W RMS
8 Ohm
UV Treated, Glass-Filled ABS
Sealed
Black or White Ma�e, Paintable
6.3" x 9.2" x 7"
(160mm x 233mm x 145mm)
5 lbs (1.87 kg)
COD-601
60Hz - 20kHz +/-3dB
1" PEI Dome Tweeter
6.5" PP Woofer
89 dB
40W RMS
8 Ohm
UV Treated, Glass-Filled ABS
Ported
Black or White Ma�e, Paintable
8.5" x 11.8" x 9.4"
(216mm x 300mm x 239mm)
7.5 lbs (3.4 kb)
Owner's Manual
COD OUTDOOR SPEAKERS