Allen-Bradley 837TH-N1 Series Installation Instructions

Installation Instructions

Original Instructions
Non-display Solid-state Sanitary Temperature Transmitter
Catalog Numbers 837TH-N1x, 837TH-N2x
Topic

Safety Considerations

Specifications
Dimensions [mm (in.)]
Wiring Diagram
Connection Cables
Commissioning
Safety Considerations
• Read this document for information on installation, handling, mounting, general product specifications, and operation of this product.
These installation instructions contain important information on handling the instrument.
• Working safety requires that all safety instructions and work instructions are observed.
• Observe the relevant local accident prevention regulations and general safety regulations for the range of use of the instrument.
• The installation instructions are part of the product and must be kept in the immediate vicinity of the instrument and readily accessible to
skilled personnel at any time.
• Skilled personnel must have carefully read and understood the operating instructions before any work begins.
• The Bulletin 837TH-N is a resistant thermometer, which is used as a general-purpose thermometer for the measurement of temperature.
The device has been safely built with state-of-the-art technology and meets the applicable requirements and EC directives. It can, however,
be a source of danger if used incorrectly or for anything other than the designated use.
• Qualified individuals are required to install and commission this device. Failure to comply results in personal injury or equipment damage.
• During mounting, make sure that the sealing faces at the instrument and the measuring point are clean and undamaged.
• Safety Installation Considerations: Before installation, commissioning and operation, be sure that the appropriate temperature
transmitter has been selected in terms of range of measurement, design, and specific conditions of measurement.
Qualified Personnel
Qualified personnel are required to conduct the described work and to recognize the potential hazards. They are able to implement the work that is
described and independently recognize potential hazards. Their technical training, knowledge of measurement and control technology, and their
experience and knowledge of the country-specific regulations, current standards, and directives allows them to install this product.
Page
1
2
3
3
3
3