Advertisement
Quick Links
Models
Input
100-250V ac
PSA-12
50/60 Hz
1.1 A max @
PSA-12E
100V ac
Environmental Rating
Operating Conditions
86.4 mm
(3.40")
Models
Length
DB906
†
1.8 m (6')
DB910
3.0 m (10')
†
DB9Y
†
1.8 m (6')
†
These models are not stocked and are non-returnable.
WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or replace, free of
charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not cover
damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied.
Printed in USA
Banner Engineering Corp., 9714 Tenth Ave. No., Mpls., MN 55441 • Ph: 763.544.3164 • www.bannerengineering.com • Email: sensors@bannerengineering.com
PSA-12 Power Supplies (12 Volt)
• 12V dc power supply delivers up to 3.5 amps to power Banner 12V continuous LED
lights
• Choose model with 120V ac North American power cord, or with 220V ac Euro
power cord
• Includes pre-wired 9-pin D-sub connector for direct connection to LED lights
• Tough ABS housing
Input
Cord
Output
North America
12V dc ±5%
(NEMA 5-15)
with voltage
regulation of ±1%
Cont. Europe
3.5 A max.
(Schuko CEE 7)
IEC IP20; NEMA 1
Temperature: 0° to 50°C (+32° to 122°F)
Maximum relative humidity: 95% at 40°C (non-condensing)
50.8 mm
(2.00")
Accessory Extension Cables
Terminated both ends with 9-pin D-sub connector, for continuous lights
(one end male pins and opposite end female pins)
Y cable for powering 2 lights from one supply, for continuous lights
Features
PSA-12 Models
Output
Cable
1.8 m (6')
Terminated with
9-pin D-sub
connector
(female pins)
149.1 mm
(5.87")
Configuration
05/01
Used with
Connections
Pin 1 = +V
Pin 2 = dc common
Continuous
Pin 3 = dc common
LED lights
Pin 4 = +V
Pin 5 = +V
1.8 m
(6.0')
P/N 67445
Advertisement
