SAF-HOLLAND RK-09429-5 Installation Instructions

WARNING
This release handle replacement kit is intended ONLY for LEFT-HAND release Generation
I and II (Gen. I and Gen. II) FleetMaster fifth wheels produced before September 1999.
Verify that your FleetMaster fifth wheel is a Gen. I or Gen. II by identifying the proper
WARNING
fifth wheel lock AND handle shown below. If your fifth wheel has a Gen. III lock or
handle, DO NOT USE THIS KIT! Contact Holland for the proper kit part number.
RK-09429 and RK-09429-5 COMPATIBILITY
OK
OK
GENERAL INFORMATION:
1.
All fifth wheel maintenance, adjustment and
rebuilding must be performed by a qualified
person using proper tools and safe practices.
2.
Do not modify or add to the product.
3.
Always wear safety goggles and never strike
any part with a steel hammer.
4.
Do not weld on this product.
5.
Observe standard safety precautions
at all times.
6.
Use only genuine Holland parts.
7.
Do not deviate from these instructions. Refer
to Holland publication XL-FW340 for Holland
TF-TLN-5001 Lock Tester instructions.
XL-FW345
Installation Instructions for RK-09429 and RK-09429-5
FleetMaster Generation I or II
(Left-Hand) Release Handle Kit
To complete the replacement procedures, the tractor must be uncoupled
from the trailer and parked, with the engine turned off, in an area clear
of other persons, vehicles, or obstacles.
GEN. I
GEN. II
GEN. III
LOCKS
2
REMOVAL AND REPLACEMENT PROCEDURES:
1.
Remove the old cotter pin, washer, release
handle, and spring and discard. Slide the new
release handle through the left (driver) side
release handle window (
INSERT NEW HANDLE THROUGH DRIVER
RELEASE
ARM
SIDE RELEASE HANDLE WINDOW
HANDLES
).
see Figure 1
FIGURE 1