Advertisement
Quick Links
YOUR
1 SOURCE FOR PROFESSIONAL
#
RACE COMMUNICATIONS... WORLDWIDE
2-WAY EQUIPMENT
INSTALLATION,
OPERATION &
MAINTENANCE
Congratulations! You have just purchased the finest in race
communications equipment from the Leader in Professional
Race Communications. Please store this manual in a safe
place. It contains important information about the use of your
equipment.
YOUR FREQUENCIES ARE:
WWW.RACINGELECTRONICS.COM
RACING ELECTRONICS
|
840 DERITA ROAD
|
CONCORD, NC
|
28027
|
1.800.272.7111
Advertisement
Summary of Contents for Racing Electronics RT605
- Page 1 Leader in Professional Race Communications. Please store this manual in a safe place. It contains important information about the use of your equipment. YOUR FREQUENCIES ARE: WWW.RACINGELECTRONICS.COM RACING ELECTRONICS 840 DERITA ROAD CONCORD, NC 28027 1.800.272.7111...
- Page 2 3) Mount RT605, RT615, RT705 and RT715 Helmet Kits by attaching the cable clamp around the middle section of the flex boom.
- Page 3 OPEN FACE HELMET INSTALLATION: 1) Remove the helmets’s inside padding on the right side. 2) Drill a 5/16” hole in the right side of the helmet positioned so that mic will touch the driver’s lips when the boom is installed. 3) Remove the bottom screw and first plastic washer from the Boom Support.
-
Page 4: Car Installation
CAR INSTALLATION: Antenna: For best performance, mount the roof-mount antenna in the center of the racecar roof. Drill a 3/4" hole in the roof of the racecar and install as shown in the diagram in your instructions. If the racecar roof is fiberglass or a non-metal composite material, we suggest first mounting an 18"... - Page 5 TIPS FOR THE DRIVER: Foam Earmolds: Compress foam evenly and insert into ear. Allow the foam to expand before putting on helmet. Hint: Hook wire over your ear from front to back to keep the earpieces in your ears better. Custom Earmolds: Lightly moisten the earmold for lubrication and they will go in the ear easier.
-
Page 6: Care And Cleaning
MOTOROLA RECHARGEABLE BATTERY - CARE & TIPS: Charge your new battery overnight (14-16 hours) before using it. New batteries can be stored up to two years without significant cycle loss. Store new/unused batteries in a cool dry area at room temperature (72 degrees F).