Ono Sokki GS-4713 Instruction Manual

●
Instructions Manual
（Resolution: 10μm）
●
（Resolution: 10μm）
（Resolution: 1μm）
（Resolution: 1μm）
■Omission of Issuance of Certificate
This product has been tested under strict conditions for
normal operation before shipment. Please note that the issu-
ance of certificate is omitted.
■Warranty
１．This product is covered by a warranty for a period of one
year from the date of purchase. Failures, if any, will be
repaired for free of charge.
２．Even during the warranty period, the following failures
will be handled on a fee basis.
・Failures or damages occurring through misuse, misopera-
tion, or modification
・Failures or damages occurring during transportation
after purchase
・Failures or damages occurring through natural calamities
(fires, earthquakes, flooding, and lightening), environmen-
tal disruption, or abnormal voltage
・Replenishment of expendable supplies, spare parts, and
accessories
３．For any questions such as those about repair after expira-
tion of the warranty period, contact the dealer from
which you purchased the product or the Ono Sokki sales
office nearby.
Ⓒ
Overview and Features
・
・
・
・
CAUTION
Part Names
LINEAR GAUGE SENSOR
Output Connector Pin Assignments and Output Circuit
μ
Linear gauge sensor
+5V
+5V
22Ω
+5V
22Ω
Frame ground
P
SIG 1
SIG 2
When pushing spindle in
P = 40μm ： GS-4700 Series
P = 4μm ： GS-4800 Series
Precautions for Use
CAUTION
●
●
●
●
13mm
μ
R03-PB6M (TAJIMI ELECTRONICS)
A
SIG 1
B
SIG 2
C
+5V IN
D
No connection
E
COM
F
COM
Connector outer tube
P
SIG 1
SIG 2
When pulling spindle out
●
●
●
Mounting to Fixing Device
【Mounting by squeezing stem】
Recommended tightening torque:0.4 to 0.5N･m
【Mounting by squeezing stem using collar】
ø18
+ 0.018
ø15H7
0
ø17
1.5 (slot)
M4 screw
Collar
Recommended collar size and material
Material: Brass
Recommended screw：Ｍ4
Recommended tightening torque：0.4 to 0.5N･m
①
②
③
●
●
●
【Mounting using the fixing holes on the main unit】
Approximately 0.2 mm
M3 screw
Mounting surface
Spring
washer
Approximately
0.2 mm
Base bottom
1.5 mm or less
M3 screw Fixing jig Tightening torque
(male screw) (female screw) （N･m）
Iron Iron 0.7
Iron Aluminum 0.52
°
μ
Measurement
＊
①
②
・