In-situ WaSP P3 Setup And User Manual

Warranty Information
Waterra In-Situ will warranty all WaSP 12 volt DC Submersible Pumps to be free from defects in material and workmanship
affecting its use for a period of 30 days following the date of purchase.
Exclusions and Conditions
The use of any pump with replacement parts or accessories, which are not supplied by Waterra In-Situ and which affect
product safety or performance, shall render this warranty and all other warranties, whether express or implied, null and
void. Should any failure to conform to this warranty appear within the term of initial sale, the manufacturer shall upon
notification thereof and substantiation that the pump has been maintained, correct such defects by suitable repair or
replacement at its own expense, purchaser being responsible for shipping and handling charges only.
The warranty does not include shipping or an obligation to provide another unit while the original WaSP 12 volt
submersible pump is being repaired or replaced. This warranty does not apply to any 12 volt submersible pump used as
rental equipment or to submersible pumps contaminated by materials harmful to such products.
This warranty does not apply to parts failure due to neglect in cleaning or unauthorized servicing the WaSP 12 Volt DC
Submersible Pump nor does it cover failure of a part caused by misuse or inappropriate use of the WaSP 12 Volt DC
Submersible Pump.
Returning a 12 Volt Submersible Pump
Waterra In-Situ requires that all customers notify Waterra In-Situ prior to returning a defective WaSP 12 Volt DC
Submersible Pump under this warranty program. The 12 Volt DC Submersible Pump will only be accepted if it has been
thoroughly cleaned and decontaminated. Please contact Waterra In-Situ for a return form.
Ordering information
Order code Description
WaSP Submersible Pumps
WaSP P2 Ø43mm 2-stage 12V submersible pump / 15m cable
WaSP P3 Ø43mm 3-stage 12V submersible pump / 21m cable
WaSP P5 Ø43mm 5-stage 12V submersible pump / 33m cable
WaSP N21 Ø37mm Narrow diameter 12V submersible pump / 21m cable
WaSP-F1 Flow Controller
WaSP-F1 Low flow controller
Accessories
LDPE 12/10-30m 30m LDPE discharge tubing (12mm OD x 10mm ID)
WTC-1 Waterra tubing cutter
CT25 Pack 25 cable ties
DC90-05 Decon 90 Cleaning Solution (5 litres)
NOTE: All pumps require a 12V - 15V DC power source (not supplied).
Waterra In-Situ recommend the use of a marine or leisure battery (not a car battery).
WaSP 12V Pumps
Set-up and user guide
WaSP P2 - 12 m lift
WaSP P3 - 18 m lift
WaSP P5 - 30 m lift
WaSP N21 - 21 m lift
Schematic
diagram
showing
connections
and method
of operation.
WaSP F1 Low Flow Controller
Optional
12V power
WaSP-F1 12V
supply
controller
LDPE
discharge
pipe from
submersible
pump
12V submersible
pump
in borehole
Pump intake
TM06 - 08/12