Selecon Arena Theatre Fresnel Operation Manual

HIGH PERFORMANCE FRESNEL (250mm lens),
THEATRE FRESNEL (200mm lens)
you in making maximum use of your luminaire, its maintenance and care. If you would like further assistance
contact your Selecon dealer or Selecon.
LAMPING YOUR LUMINAIRE
The Arena Fresnel & PC range is supplied with a G22 lamp socket for the CP91 2500W or CP92 2000W
lamp.
OR the GY 16 for the CP 72 2000W lamp.
Before relamping – DISCONNECT THE LUMINAIRE FROM THE POWER SUPPLY. Be aware also that
the lamp or luminaire may still be hot, so exercise necessary caution to avoid burns. Please note
also that these luminaires are not suitable for mounting on a normally flammable surface.
Release the clip fastener and swing down the rear door.
Insert lamp taking care not to touch the quartz envelope with your fingers.
Close door and lock off the fastener.
Reconnect the luminaire to the power supply and bring up on the dimmer.
Adjust focus as per Focus notes on page 2.
MOUNTING YOUR LUMINAIRE
Your luminaire uses a theatre lamp with a grid filament. To avoid premature lamp
failure it is essential that the luminaire is always mounted do the yoke is horizontal
and with the lamp base down, i.e: the lamp adjustment knob is at the bottom of the
rear lamp plate.
Version 2: September 2004
ARENA
& PC
OPERATION MANUAL
IMPORTANT NOTE:
Before discarding the
packaging ensure you
have the suspension bolt
set, colour frame /or the
lamp.
THANK YOU FOR PURCHASING AN ARENA LUMINAIRE.
WE HAVE DESIGNED THIS LUMINAIRE TO PROVIDE YOU WITH A
SUPERIOR FITTING IN PERFORMANCE, DESIGN & ENGINEERING.
WE ARE CONFIDENT THAT IT WILL PERFORM TO YOUR
EXPECTATIONS FOR MANY YEARS TO COME.
Before operating your new luminaire please read this information to assist
© 2004 Selecon New Zealand Limited All Rights Reserved