Commissioning
• Reattach the product to the wall back by refitting the
screw set aide earlier. Make sure the seals are tight
to ensure ingress protection.
• Adjust the PIR sensor as detailed below.
PIR Adjustment
The PIR sensor can be adjusted for duration the lamp
stays on ("TIME" screw) and the light level that the
switch activates ("LUX" screw).
To adjust when the switch activates, rotate the "LUX"
screw between the sun and moon symbols. The sun
indicates the PIR sensor will operate at all times
during daylight and darkness. The moon indicates
that the PIR sensor will operate in total darkness only.
Care and Cleaning
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
www.saxbylighting.com
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
To adjust the duration the lamp stays on, rotate the
"TIME" screw between + and - . Minimum time on
is 10+/-5 seconds maximum time on is 4+/- 1
minutes
Iss.2 26052016
Saxby Lighting Ltd. BH23 3PE
Instruction leaflet
PIR Sensor
67346, 70471