B+B SmartWorx FOSTCDR Quick Start Manual

Product Overview

Terminal
Blocks
1
UL Installation Guide
Underwriters Laboratories Conditions of Acceptability –
When installed in the end-use equipment, consideration
should be given to the following:
1. The wiring terminals are suitable for factory wiring only.
2. This device is to be mounted in a suitable enclosure in
the end-product.
3. This device is suitable for operation at a maximum
surrounding air temperature as described in the
documentation.
4. These devices are intended for use in a pollution
degree 2 environment.
-Input Voltage: 10 – 30 VDC
- Input Power 4.2 Watts
- Wire Range: 12 – 24 AWG
- Tightening Torque: 4 kgf-cm
- Temperature rating of filed installed conductors is
105 C minimum, sized for 60 C ampacity.
- Use copper wire only
- Maximum surrounding ambient air temperature
80 C
2
Baud Rates
Baud 1 2 3
4800 OFF OFF OFF
9600 OFF OFF OFF
19.2K OFF OFF ON
38.4K OFF ON OFF
57.6K
ON OFF OFF
76.8K ON OFF ON
115.2K ON ON ON
3
Terminal Block
Fiber
Connectors
LEDs
4
Wire the Converter

DIP Switch

RS-232
RS-485 2 Wire
4 5
OFF ON
ON OFF
OFF OFF
OFF OFF
OFF OFF
ON OFF
OFF OFF
Terminal Signal
A RS-232 RD (OUTPUT)
B GND
C GND
D
RS-232 TD (INPUT)
E NOT CONNECTED
F +10 TO 30 VDC
G RS-422/485 TDA ( - ) / DATA A ( - )
H RS-422/485 TDB (+) / DATA B (+)
J
+10 TO 30 VDC
K RS-422/485 RDA ( - ) / DATA A ( - )
L RS-422/485 RDB (+) / DATA B (+)
RS-422/RS-485 4 Wire

Fiber Optic