Cobalt Digital Inc BLUE-IMC User Manual

QUICK START

1. Connect the PRYMEBLU adapter to a compatible two-way radio.
2. Pair the PRYMEBLU Adapter with a compatible wireless audio accessory.
3. Connect a wired audio or PTT accessory to the Quick-Disconnect accessory port
on the PRYMEBLU Adapter (optional). NOTE: Not all models have a QD jack.
4. Test and use.

Connecting the Adapter to Radio

STEP ONE: Connecting to Two-Way Radio
To connect your COBALTBLUEAdapter to a two-way radio, follow these steps:
* Always turn off your two-way radio before connecting the COBALTBLUE Adapter.
* Plug the COBALTBLUE adapter into the speaker-microphone / audio accessory jack of your two-way radio.
* On some models of two-way radio, you may need to tighten a retaining screw to ensure that the
COBALTBLUE adapter remains attached to the radio
* Turn on your two-way radio and verify that the radio transmits and receives with the adapter attached.
* Because no wireless audio accessory will yet be paired to the COBALTBLUE Adapter, received signals
should be heard over the radio's internal speaker and transmitted signals will be sent using the radio's
internal microphone.
* The Talk button on the COBALTBLUE Adapter will not function as a Push-to-Talk button for your two-way
radio until a wireless audio accessory is successfully paired to the adapter, or a wired audio accessory is
plugged into the Quick-Disconnect port.
3

Controls and Connection

Quick Disconnect Accessory Port
Allows the connection of a COBALTBLUE
series wired audio accessory, such as a
Push-to-Talk, earphone, or auxiliary
microphone. (Not present on all models.)
Radio Connector
This port connects the COBALTBLUE
Adapter to a compatible two-way radio.
NOTE: BLUE-MXT Model shown.
Other models may vary slightly
in appearance.

Pairing With an Audio Accessory

STEP TWO: Pairing with an Audio Accessory
* Turn off the radio that the COBALTBLUE Adapter is connected to. Wait at least three seconds.
* Turn the radio on while holding down the Talk button on the COBALTBLUE Adapter.
* Continue to hold the Talk button down for approximately three seconds. Release the Talk button
when the status LED begins to flash two times per second.
* The COBALTBLUE Adapter is now in audio accessory pairing mode. Activate the pairing mode on
your compatible wireless audio accessory.
* Once the wireless audio accessory and COBALTBLUE Adapter are paired with each other, the status
LED on the adapter will show a constant blue light for three seconds.
* If the COBALTBLUE Adapter does not detect a compatible wireless accessory within 60 seconds
of being put into pairing mode, the adapter will exit the pairing mode and resume normal operation.
* Once successfully paired, you will be able to operate your two-way radio using your compatible
wireless accessory.
Multi-Function Talk Switch / Status LED
Used to place the COBALTBLUE Adapter in pairing
mode.The LED flashes messages that let the user
know the current status of the PRYMEBLU Adapter.
Once paired with an audio accessory, this switch is
used to activate the Push-To-Talk function of the
two-way radio.
2
4