LITEWAY VT-4005 Operating Instructions

WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it's subsidiaries are fully tested
prior to shipment and are warranted against defective materials
and workmanship for a period of five full years from the date of the
original shipment. Should a problem occur, a Return Material
Authorization Number (RMA) must be obtained from Liteway Inc.
at (516) 931-2800 and the item returned to Liteway, Inc. 166
Haverford Road, Hicksville, NY 11801, USA, prepaid. Liteway Inc.
will then, at its option repair or replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the
cost of the defective item only. No contingent liabilities of any kind
are either assumed or implied.
Any items returned to Liteway, Inc. that have been misused,
abused, damaged, modified, connected or adjusted in any way
contrary to the instructions furnished by Liteway, Inc. or repaired
by unauthorized personnel will not be covered by this warranty.
Any non-warranty repairs required will be quoted at the current
rate for such services.
!

Important Notices

CAUTION ! AVOID DIRECT EXPOSURE TO BEAM.
All –5, -7, -8, and -9 Models use laser diodes. These solid-state
laser diodes are located in the optical ports of these units. Laser
diodes produce invisible radiation that may be harmful to human
eyes. Never look directly into the optical port of any fiber optic
unit designed to operate with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications
of any kind.
© Copyright 2017 Liteway, Inc. 108486 Rev D

OPERATING INSTRUCTIONS

Fiber Optic Video
Transmission System
Models; VT-4005, VR-4005
Models; VT-4010, VR-4010
Models; VT-4100, VR-4100
The VT/VR-4005 system consists of the VT-4005 transmitter and VR-
4005 receiver. A high quality system for transmitting up to 5 CATV
VSB/AM video channels over fiber optics. Perfect for using in
campus environments. Fiber optics provide for complete EMI
immunity. The VT/R-4010 will transmit 10 CATV channels.
The VT/R-4100 will transmit 125 CATV channels.
Technical Specifications
Bandwidth 5 MHz to 300 MHz (VT/R-4005)
5 MHz to 700 MHz (VT/R-4010)
5 MHz to 1200 MHz (VT/R-4100)
In/Out Impedance 75 ohms
In/Out Signal Level 10dB mV
Carrier/Noise Ratio 44 dB minimum
Signal Connector BNC (with Type F adapter included)
Operating Wavelength 850 (-1), 1300 (-3,-7), 1550 (-9)
Optical Output -14 dBm typical
Optical Loss Budget 0 – 12 dB
Fibers Accommodated 1 Multimode (-1,-3), 1 Single-mode (-7,-9)
Temperature Range -35º to +75ºC
Power Requirements 11-24 VAC/DC @150 mA
Physical Size (mm) 5.0"(127)L x 1.0" (25.4)W x 3.0"(7)D
All specifications measured with 1Km of 62.5u multimode fiber.
All specifications are subject to change without prior notice.