Summary of Contents for HAZVAC EC-12 HEPA
- Page 1 HAZVAC INDUSTRIAL VACUUM CLEANER WITH HEPA FILTER FOR WET AND DRY RECOVERY INSTRUCTION MANUAL FOR MODEL EC-12(G) HEPA TO ENSURE A SAFE WORKING ENVIRONMENT, CAREFULLY READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS...
-
Page 2: Table Of Contents
TABLE OF CONTENTS PAGE INSPECTION IMPORTANT HEALTH AND SAFETY PRECAUTIONS IMPORTANT SAFETY PRECAUTIONS GROUNDING INSTRUCTIONS OPERATING INSTRUCTIONS FOR DRY RECOVERY OPERATING INSTRUCTIONS FOR LIQUID RECOVERY INSTALLING AND REPLACING HEPA FILTER MAY 2002... -
Page 3: Inspection
Page 1 INSPECTION Carefully unpack and inspect your Hazvac. Each vacuum cleaner is tested and thoroughly inspected before being shipped; therefore, any damage is the responsibility of the delivering carrier, who should be notified. Read all instructions carefully before operating vacuum cleaner. -
Page 4: Grounding Instructions
Page 2 Do not run vacuum cleaner over cord. Keep cord away from heated surfaces. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. Do not handle plug or appliance with wet hands. Do not put any object into openings. Do not use with any openings blocked;... -
Page 5: Operating Instructions For Dry Recovery
Page 3 OPERATING INSTRUCTIONS FOR DRY RECOVERY Suction intake Floater Exhaust silencer / working air exhaust Cooling air intake Cooling air exhaust Paper filter bag Polyester filter with clamp HEPA filter Release latches and remove power-head from recovery tank. WARNING: Make sure that the HEPA FILTER is properly installed prior to use. -
Page 6: Operating Instructions For Liquid Recovery
Page 4 OPERATING INSTRUCTIONS FOR LIQUID RECOVERY Suction intake Floater Exhaust silencer / working air exhaust Cooling air intake Cooling air exhaust Polyester filter with clamp HEPA filter Release latches and remove power-head from recovery tank. Remove pvc pipe connector and remove paper filter bag. Clean out inside of recovery tank. -
Page 7: Installing And Replacing Hepa Filter
Page 5 INSTALLING AND REPLACING HEPA FILTER Unscrew the three hex nuts which hold the HEPA housing to the lid. Remove contaminated filter and Install a new filter of the same configuration. Tightly fasten HEPA housing to lid with three hex nuts. Make sure that all protective gaskets form a perfect seal in and around the HEPA housing.